The thermostat is located in the housing where the top radiator hose connects to the engine. You will have to disconnect the hose and unbolt the housing to get to the thermostat.
I believe you want to drain the coolant, remove the top hose at the thermostat housing, remove the housing, replace the stat and gasket, reassemble fill with coolant and bleed the system.
how do u replace alternator on 2004 pontiac bonneville gxp
How do you replace passenger side fender on a 1998 pontiac bonneville se
How do you replace the ignition swith opn a 1992 Pontiac Bonneville se
how do you replace a blend air door assembly on a 2000 pontiac bonneville
just need to know where it is located on car
The thermostat is on the top of the motor where the top radiator hose attaches to it. The housing for it should be held on with two bolts. Remove the bolts and lift up the cover. There's the thermostat.
replace temperature door actuator.
locate blend door actuator for 1997 pontiac bonneville se
How to remove left inner door panel of a Pontiac Bonneville 1996
I would like to have a dimgram to show me how to put the hater core out and in on my 94 Pontiac Bonneville
You remove the old one and put a new one
removed thermostat on 98 Bonneville and also removed rubber seal -- cannot get the old seal back into the housing.... help
The lighter module on a Pontiac Bonneville can be removed by unscrewing the mounting hardware. The lighter will then be able to be pulled off the center console.
how to change steering column on 86 pontiac bonneville
With a Hammer
where is the thermostat located in a 1999 Toyota Camry located and how do you replace it.
The cam shaft sensor is located behind the water pump pulley. One bolt that holds it in place.
The thermostat is located inside the radiator. Remove the radiator cap and pull the thermostat up. Remember to put the replacement thermostat in the same position push the new thermostat down in the radiator. The O-ring gasket will automatically seal.
Start off by removing the top engine cover carefully so that it does not brake............Drain the cooling system.Partially drain the cooling system.Remove the air cleaner assembly.Remove the radiator outlet hose from the thermostat housing.Remove the bolts securing the thermostat housing to the water pump inlet.Remove the thermostat and the gasket from the water pump housing.
To replace the thermostat on a 1997 Pontiac Grand Am 3.1, first disconnect the negative battery terminal and loosen the clamp on the radiator hose. Next, remove the mounting bolts from the thermostat housing and insert the new thermostat.
that all depends on which engine you have. eiter the 3.0 or 3.4 or3.8 how ever the termostat housing should be located oppsite the water pump or right on top near the intake. either way alls you have to do is remove the the 3 bolts to the thermostat housing pull the old one out and put new one in.
remove old thermostat and replace with new thermostat and gasket