This is easy, never change hot !!!! you will be burned!!! Follow the lagre hose at the top of your radiator, you will come to where it ends at a domed shaped connector. This is the housing. remove the hose then take out the 2 bolts on the housing. Take out the thermostat and inspect for missing pasts. clean the old seal off of the head and housing, replace the thermostat and seal. make sure you do not put in the new one upside down, look at the old one when removing. Put the hose back on and check fluid levels, replace if needed.
follow the top radiator hose to the engine, remove it then remove the thermostat housing, remove the thermostat and replace it
Where is the thermostat located on a 1996 Toyota Tercel?
Need to know where is the thermostat located on a 1996 mercury tracer.
Need to know where is the thermostat located on a 1996 Mercury tracer.
Locate thermostat on 1996 Acura RL
To replace the thermostat on a 1996 Pontiac Transport, first, ensure the engine is cool and disconnect the negative battery cable. Drain the coolant from the radiator, then remove the upper radiator hose attached to the thermostat housing. Unbolt the thermostat housing to access the thermostat, replace it with a new unit, and reassemble by reversing the disassembly steps, ensuring to refill the coolant and check for leaks.
Loosen the alternator bracket, move it out of the way. The thermostat is at the end of the upper radiator hose where it curves into the engine
Below-
The thermostat is usually located on the lower hose, where it attaches to the radiator
You can uninstall thermostat and install new thermost under air filter and look coolant hose by sensor gang. I did my own car.
The thermostat is located inside of the thermostat housing on the front of the engine. You can follow the top radiator hose to the thermostat housing.
1996 3.1 litre ThermostatThe thermostat on a 3.1 litre is located under the throttle body where it connects to the intake manifold. I found it was easier to remove the throttle body when replacing the thermostat. You first have to remove the throttle cable bracket that is mounted on the throttle body. After that you will be able to see the thermostat housing. The bottom hole on the thermostat housing is slotted so you don't have to completely have to remove it. Good luck!