Remove the 2 bolts at the thermostat housing. The upper hose goes to the thermostat housing.
My 97 4.0 Ranger's thermostat is in the front of the engine. I has two bolts you have to take off. I had to replace the gasket. Leaked when I got on it hard. It's called the "thermostat housing. Thermostat is easy to replace. Great engine.
this site^ will show you a how
follow the top radiator hose to the motor the hose is clamped to the thermostat housing remove the housing and you will find your thermostat
do you have to remove fan shroud to access thermostat housing on a 1997 2.3L ford ranger
stand at the front of the car and look for the top rad hose and follow it to the end there should be two bolts holding the hosing unbolt and replace the thermostat and gasket
Drain the water from your 1997 GMC Yukon cooling system. Remove the water supply hose. Remove the thermostat housing retaining bolts. Remove the old thermostat and replace with the new thermostat.
I need a picture diagram for a 1997 Ford Ranger engine so I can locate where the thermostat is? Please help!!!
The 1997 VW Jetta thermostat is located inside of the thermostat housing. Remove the thermostat housing retaining bolts. Remove the water supply hose. Reverse the process to install the new thermostat.
The thermostat is located underneath the radiator hose where it connects to the engine. The thermostat regulates the engine's temperature.
To replace the thermostat on a 1997 Pontiac Grand Am 3.1, first disconnect the negative battery terminal and loosen the clamp on the radiator hose. Next, remove the mounting bolts from the thermostat housing and insert the new thermostat.
The 1997 Ford Ranger engines are fuel injected , so no carburetor
unscrew take old out, drop new in with gasket put baqck screws IF YOU DONT KNOW HOW TO CHANGE A THERMOSTAT, LEAVE YOUR HOOD CLOSED!
Most stats are located in the thermostat housing at the bottom of the upper radiator hose.
follow the top radiator hose to the engine and there will be two half inch bolts pull the housing off and that is your thermostat, replace in same position as the old one. p.s. is car overheating may not be thermostat, you can test thermostat in pan of boiling water and see if it opens or closes.
the thermostat is located behind the water pump. there are 2 8mm bolts holding it in. unscrew, pull old thermostat out, put new one in and put back together. Simple - 9 I would have given it a 10 but the bottom bolt can be a pin to get to.
The 1997 Nissan Ultima thermostat is located on the front of the engine. You can follow the water supply hose from the radiator to the thermostat housing.
the thermostat is located on the front side of the intake manifold easy to get at
The thermostat on a 1997 Ford F-250 is located under the upper hose assembly in the radiator. To locate the thermostat, drain the radiator halfway and remove the hose at the top of the radiator.
The thermostat on a 1997 Chrysler Town and Country is located under the housing where the upper radiator hose attaches to the engine.
The thermostat on a 1997 Mazda MPV is located on top of the engine, under the upper radiator hose. It controls the flow of coolant through the vehicle.
The bleeder valve for the brakes on a 1997 Ford Ranger is located in the brake line where it meets the brake disc. The wheel will have to be removed to access the bleeder screw for drum brakes.
In a 1997 Ford Ranger, the wiper control module is located behind the radio compartment. It sits on the left side of the compartment.
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT