Top Answer
User Avatar
Wiki User
Answered 2008-09-20 23:44:28

It is at the engine end of the top radiator hose.The housing is the thermostat housing and the thermostat is located therein.

User Avatar

Your Answer

Related Questions


The thermostat is located in the housing at the engine end of the top radiator hose.

5W-30 is most recommended for a 2006 Chevy Impalawith a 3.5 liter motor. 5W-30 is most recommended for a 2006 Chevy Impala with a 3.5 liter motor.

What are the torque specs for 2000 Chevy Impala 3.8 Litre ?

Where is the thermostat located at on a 2004 Chevy Malibu 3.5 liter V6

where is oil sending unit located on 2003 chey impala 3.8 liter

It is in the thermostat housing at the end of the top radiator hose on the engine side.

i have the 3.4 liter 2000 impala and its up against the top of the firewall towards the middle of the engine

The 3.4 liter V6 engine in a 2001 Chevrolet Impala has a timing CHAIN

The charger is faster as the Chevy has a 6 cyl.

information on how to change the themostat on a 94 Pontiac Grand am SE 2.3 liter

Underneath the top radiator hose where it goes into the top of the engine.

Look on you tube to see if there is a video on it.

3.6 liter V6 = 18 city 30 highway

Remove the water hose from the top of your 1996 Chevrolet 2500 thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out and drop in the new thermostat.

The thermostat on a 6 liter 2003 Chevy express is located on the left side of the water pump. The thermostat is a one piece unit attached to the thermostat housing, which is then mounted to the upper left side of the water pump. The average cost for this one piece thermostat/housing is around $25.00.

thermostat sticking closed then snapping open

Ihe top radiator hose leads into a removable water neck on the engine. It has 2 bolts. You have to remove all the plastic intake crap to get to it. Remove it and the thermostat is in there. Make sure you replace the o-ring and gasket.

The 2000 Chevy Impala 3.4 liter engine rocker arm bolt torque specification is 45 pounds. The rocker arm bolts should be torqued in 15 pound intervals.

This depends on a couple of factors, including the year of the vehicle and whether the engine is the original. The latest model (the 2012 Chevy Impala) will include GM's 3.6 liter v6 engine; it reportedly packs 302 horsepower.

Follow the top rad hose to the engine , There you will find the housing undo bolts , clean gasket on housing replace with new gasket and thermostat. Make sure engine is cool and drain anti-freeze first

Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.