This might get you started...
The drive gear is broken in the window motor. Remove motor and install gear kit.
The cable runs through and is coiled inside the motor. It is advised to replace as an assembly.
HOW DO I REPLACE WINDOW REGULATOR MOTOR ON PASSENGER SIDE WINDOW
How do you remove and replace the motor for the drivers side power window in a 2000 Sienna
for what car? 2000 gm s15
how do you replace ambient light sensor on 2002 silverado
How do you go about replacing the pitman arm on a 2000 Silverado?
For that you will have to remove the whole window mechanism. Then you will be able to replace the motor. When you assemble the mechanism make sure that you have set up position of the gears properly.
well iam a retard you have take off the door panel to get to the motor but to replace the window switch get a flathead sd and stick it under the front of the switch holder and lift up
Remove the inside door window panel. Make sure the window is on the window track. Make sure the window linkage is not needing repair. Replace the window motor.
Breaking this question into the 2 primary components: how to remove the door panel - and - how to replace the window motor. Both are well covered in the "Related Questions" below
remove your door panel there will be three screws holding it on. then you have to remove the screws holding your window to the regulator. then unbolt regulator and motor from door. Undo wiring going to motor.
Plug the switch back in and roll it up. Or if the motor is fried you have to find the window pinch bolts and loosen them then lift window up and put a peice of tape from window to top of door to hold it up.
The regulator is shot. Replace the regulator.
Go to autozone.com and sign up then go to the repair tips section and print what you need. answer remove inside door lining u will need window up remove bolts that hold window moter in door put hand inside door and remove to rplace just work backwards from removing
It is easy to replace the window regulator or window clips on the rear window of a 2000 Grand Am. The clips simply snap right onto the rails inside that door that connect to the window.
The relays are integrated into the switch itself.
Unbolt it and buy a new one
the blower motor relay is located next to the blower motor it is connected to the motor by a purple and black wires
You will have to replace the complete window regulator assembly.
www.2carpros.com/how_to/power_window.htm i dont realy know but its on this website ^^^ ^ lol
How to time a 6 cylinder motor