Remove the door panel, just a couple of screws. unbolt the regulator from the window and push the window back to remove the studs from the regualtor holes. push the window all the way up and run a piece of tape from inside the glass around the top of the door and to the outside of the glass at the front and rear of the window. the regulator is bolted in with 4 bolts, two at the top and two at the rear. once unbolted, you'll have to cut the zip tie in order to rotate the two regulator run channels to manuevur them out of the door. just reverse the procedure to install. before you tighten the regulator all the way, bolt the window up and pull up and back on the upper back corner of the window to prevent any wind leaks
replace window regulator assembly.
how to replace power window motor for 2003 dodge grand caravan? how to remove side panel dodge caravan 2003?
first take of the door panel. Next you will see the window regulator. The there is going to be 4 bolts or so that you are going to need to take off, after that unhook the window. Then pull the whole window regulator out and replace the whole thing
tom
it is internal to the pcm (engine computer)
There isn't a vacuum line going to the regulator on a 1998 Dodge Caravan.
its a exhausts gas regulator Exhaust gas recirculation valve. You usually need to replace it.
The engine computer is the voltage regulator.
If the cables have failed, the entire regulator needs replaced.
Very difficult. I would leave it to a glass shop.
The engine computer is the voltage regulator.
The voltage regulator is part of the engine computer.