you will need an obd-2 scan tool to reset the codes, or just disconnect thebattery for 10 -20 seconds and you are good to go.
Be aware that you woill need to drive for about 30 minutes before the computer will scan as ready after that.
Just unhook the battery cables for 5 mins, That will reset the ECM
Disconnect the battry for one hour: then reconnect-That should do it.
You DONT the ECM Electronic Control Modual does it for you...
To reset the ECM on a 2004 VW Beetle an diagnostic tool should be used. Plugging the unit directly to the diagnostic tool will allow a user to directly reset the computer.
You can't. You need to find out why it is on. Requires equipment to interface with the ECM.
You can reset the ecm with a scan tool or by unhooking the battery.
Where is the ecm located in a 2000 Chevy Malibu
i am looking for fuse ID plate card and can not find one anywhere did not have a manual with this truck. It is a 08 dodge ram 350 6.7 need to pull ECM fuse and reset but canot find witch one it is.
Your ECM has deteced a problem with the emissions system. The light can be reset after the problem is repaired. You need an OBD2 scan tool to reset the light.
To reset the ECM remove the battery cable (s) for a few minutes. Replace cable. ECM has been reset.
no ECM's in a 1981
inside the ecm