The easiest way to reset the 2001 Toyota check engine light is to remove the check engine light fuse. The fuse can be found in the fuse box.
check out this website it tells you how to repair the handle since it cost about $65.00 to buy a new one. http://www.findonefindall.com/toyota-sienna/
it means you need to check the engine
Low fluid levels in engine.
The gas cap was loose on my '04 Sienna. How's that for simple...
must be a oxygen sensor
Remove the battery head(+v) for a while, then replace it and star the engine.
i have check engine light on code po171 system to lean i changed o2 sensor check engine light came back soon after, i heard that it could be fuel air ratio sensor,where is it located on 6cyl Toyota sienna, do you have any input thanks tony
When the light comes on it's telling you to read the engine diagnostic codes.
How To Fix vsc,trac off and engine light on for 2009 Toyota Sienna
After repairing the cause for the code, you can clear code with a scan tool.
If the check engine light is flashing the engine is misfiring. Most likely a bad ignition coil.
You can reset the check engine light on a Toyota by removing the battery cables and touching them together. Other than that, you will have to take the car to a mechanic and have them run a scan tool to turn the light off.
Usually a problem in the emission control system-have vehicle scanned to determine the problem
Trouble code P0770 means:Shift solenoid E malfunction
The Toyota Sienna should have high and low marks on the side of the brake fluid reservoir. Check to see that the fluid level is between the two marks.
You can either go to a mechanics shop to have the check engine light reset or you can do it manually by yourself. You will need to remove the negative battery terminal for 1 minute and then reconnect it.
Press the odometer button while starting the vehicle. Keep holding down the button until the numbers disappear and the check engine light goes out. Release the button and all is well.
It is important to pay attention and understand why the warning lights come on. The Check Engine light will flash because there is in issue within the cars engine, the number of flashes usually indicate the code number.
Bp i believe is great used hess, getty, sunoco and engine would knock like crazy. Also my check engine light would turn on with the others...
Disconnect the negative battery cable for five minutes. This should reset the check engine light. But know that if you have not repaired the problem that set the light in the first place it will just come back on.
The check engine light could any number of things. It is impossible to know what the light means without having the car checked by a mechanic. The mechanic will then be able to tell what is wrong with the car.
There are many reasons why a check engine light could come on following a timing belt change. When the check engine light comes on there is a code stored in the computer to tell you why the light came on. Most auto parts stores will read the code for free.
There are a number of places where one can purchase a 2004 Toyota Sienna. One may first want to check out local used car dealerships. One can also check out websites such as Auto Trader, Kijiji or eBay.
It is located in the fuse/relay box in the right hand side of the engine compartment. Mine is blue in color. Check your manual for further information.