Ford Ranger
Mercury Villager
Check Engine Light
VW Jetta

How do you reset a check engine light on a 2001 mercury villager?

121314

Top Answer
User Avatar
Wiki User
2006-07-21 13:59:18
2006-07-21 13:59:18

take it to auto zone and ask them to check and then clear the codes or remove the positive battery cable and press the brake pedal for 30 seconds.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.

User Avatar

By bringing it to a trained mechanic so they can check the engine is running properly (which if the light is on it's probably not)

User Avatar

have vehicle scanned to determine problem

User Avatar

The easiest way is to unhook the battery for a minute.

User Avatar

You either need a scan tool, or unhook the battery for a minute.

User Avatar

If the 1993 Mercury Villager runs rough when the check engine light comes on and the code reader says 34 and 51, there is a problem with an oxygen sensor and the MAP (Manifold Absolute Pressure) sensor. Both parts together will cost around $200.

User Avatar

There are many, many things that can cause the MIL to light up. You will need to have the problem diagnosed by first reading the codes and going from there.

User Avatar

On a 1997 Mercury Mountaineer : The " CHECK ENGINE " warning light is just to the left of the battery voltage gauge

User Avatar

If your check engine light is flashing , an engine cylinder misfire has been detected

User Avatar

IF the computer was really defective, either the car would not run, or there would be a check engine light due to a fault code.

User Avatar

my check engine light stays on and the o/d light blinks....what could this mean?

User Avatar

If you have a bad injector, chances are that you will also have a dead cylinder. Auto zone can check that for free if your engine light is on!Good luck!

User Avatar

If the o2 sensor is bad, replace it. If the sensors are activating the check engine light, then the codes should be checked. The catalytic converter could be blocked or the engine may not be running properly.

User Avatar

Inside the engine compartment by the passenger strut tower

User Avatar

None. Engine timing is set by the PCM, you can not change it with a timing light.

User Avatar

Either have the problem that is causing the light to illuminate fixed or disconnect and reconnect your battery.

User Avatar

If the check engine light is blinking that means that an engine cylinder misfire has been detected

User Avatar

You don't. Unhook the battery for a minute. That will reset it.

User Avatar

The check engine light comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, a check engine light is lit when there is a problem in the emissions or somthing that is affecting the effectiveness of the emissions. If the check engine light is flashing a misfire has been detected

User Avatar

The check engine light comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, a check engine light is lit when there is a problem in the emissions or somthing that is affecting the effectiveness of the emissions. If the check engine light is flashing a misfire has been detected

User Avatar

Motor oil level, and Motor oil Pressure**************************************If that looks OK, try www.vehix.com


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.