SRS sensor lights have a warranty extention. There is a factory problem with the SRS light coming on. Call your dealer. Your car has to have under 150,000 miles on it.
There are no external airbag sensors on a 2001 Ram.There are no external airbag sensors on a 2001 Ram.
The airbag can not be reset and must be replaced if it has deployed.
= How do you reset the Airbag light on a 2001 Nissan Maxima SE ? =
where is the right side exterior airbag sensor located on a 2001 lincoln ls v8
how to reset
There is no reset for the SRS sensors. Take this vehicle to a professional for repair. Working on the SRS is not a DIY repair. Serious injury can occur when dealing with the SRS.
i have an acura cl 2001 what does the ! light on thr dashboard mean
Last I heard you had to plug into the computer using the OBDII port to reset the airbag light. Hope this helps.
airbag light is on dash
has the airbag been replaced? if it has, take it back to who ever replaced airbag. reset should have been done when new airbag installed,as part of the proper installation
The airbag light stays on when the computer has detected a malfunction and set a trouble code. The light can not be reset until the failure has been repaired.
The light will reset itself when the cause of the code has been repaired.
The sensors that determine if the seat is occupied (and thus arm the airbag) .... are located within the seats themselves.
The impact sensors are under the front bumper.
This must be taking to a qualified person to have checked out.
The check engine light for the 2001 Isuzu Rodeo often comes on because of a sensor that is damaged or malfunctioning. The most common sensor is an oxygen sensor and when reset, this often allows the light to be reset.
Chrysler does not use reset switches.Chrysler does not use reset switches.
The airbag computer has detected a malfunction. You will need to take it to a qualified service shop for repair.
Turn key to position 2 and hold select and reset together for 10 secounds
always remove battery terminal when replacing sensors.That is your reset.
There isn't a reset for the oxygen sensors. When a repair is made then you need to have the computer cleared.jd
you turn the key to on position hold the select and reset buttons for 10 seconds and it should go off
Probably the speed wheel sensor needs to be reset
Push the select and reset switch at the same time, turn the ignition switch ON (II), and hold them more then 10 seconds. The above sentence came straight from the 2001 Acura TL service manual