0
just press and hold the two buttons beside the display until zeros appear.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove the wrench light from overhead console on a 2001 mercury cougar?
Well, I know that on a 2000 merc cougar, if you press and hold the "Select" and "Units" buttons at the same time, it will reset the light. Hopefully this helps.
What are the 3 buttons on the center overhead console for 2000 olds bravada?
They are programmable for a garage door opener
2003 dodge ram overhead console removal?
I googled "04 Dodge Ram Manual" and downloaded the service manual from one of the links, which is different than the owners manual. The service manual is 2000+ pages long....here's what is says about the overhead console removal procedure....REMOVAL OVERHEAD CONSOLE REMOVAL (1) Disconnect and isolate the negative battery cable. (2) Remove the overhead console retaining screws, located in the sunglass storage bin. (3) Using your fingertips, grasp the sides of the overhead console and pull straight down evenly to disengage the two snap clips at the front of the unit. (4) Lower the overhead console far enough to access the wire harness connectors. (5) Disconnect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connectors. (6) Remove the overhead console from the vehicle. INSTALLATION (1) Position the overhead console in the vehicle. (2) Connect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connectors. (3) Grasp the sides of the overhead console and push straight up evenly to engage the two snap clips at the rear of the unit. (4) Install the overhead console retaining screw, located in the front of console. Torque the screw to 1.2 N·m (10 in. lbs.). (5) Connect the negative battery cable. I googled "04 Dodge Ram Manual" and downloaded the service manual from one of the links, which is different than the owners manual. The service manual is 2000+ pages long....here's what is says about the overhead console removal procedure....REMOVAL OVERHEAD CONSOLE REMOVAL (1) Disconnect and isolate the negative battery cable. (2) Remove the overhead console retaining screws, located in the sunglass storage bin. (3) Using your fingertips, grasp the sides of the overhead console and pull straight down evenly to disengage the two snap clips at the front of the unit. (4) Lower the overhead console far enough to access the wire harness connectors. (5) Disconnect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connectors. (6) Remove the overhead console from the vehicle. INSTALLATION (1) Position the overhead console in the vehicle. (2) Connect the EVIC, CMTC electronic module and the reading/courtesy lamps electrical connectors. (3) Grasp the sides of the overhead console and push straight up evenly to engage the two snap clips at the rear of the unit. (4) Install the overhead console retaining screw, located in the front of console. Torque the screw to 1.2 N·m (10 in. lbs.). (5) Connect the negative battery cable.
How do you replace the overhead console lamp and the steering wheel lamps on an Oldsmobile Silhouette?
I had taken my 2000 Silhouette in for other problems and since I had it in the shop, I asked about the lamps on the overhead console and on the steering wheel remotes for the radio. They told me that the lamps are not replaceable, but the whole switch has to bed replaced. I thought that this was quite a bummer.
What kind of transmission in a 2000 chevy astro van?
The transmission in a 2000 Astro is a 4L60E.
Why would the ext temp overhead console and clock not function but then come on mid-drive in a 2000 GMC Jimmy?
sounds like it could be a loose connection.
Will doors from a 2000 astro fit a 2006 astro?
Yes
Heater sensor circuit Chevy Astro 2000?
heater sensor circuit Chevy astro 2000
How do you remove the overhead console on a 2000 Pontiac Montana?
There are 4 Phillips head screws. One that you can see at the front leading edge. The other three are hidden in the storage cubbys of the console. Just open the doors and look with a flash light...you will see them. The console is very light and will hang by the switch wires when you unscrew it.
How do you reset the overhead perform service light on a 2000 Jeep grand Cherokee?
Key on and shut the doors. Press "step" until "0 miles to service" is displayed. Now press and hold "reset" until the mileage resets.
Where is the switch to reset the alarm in a 2000 Chrysler Sebring JXI Convertible?
A 2000 Chrysler does not have a reset switch.A 2000 Chrysler does not have a reset switch.
When was Console Classix created?
Console Classix was created in 2000.
