To reset the service reminder on a 2010 Range Rover Sport, turn the ignition on without starting the engine. Press and hold the accelerator and brake pedals simultaneously for about 10 seconds until the service light flashes and then turns off. Release the pedals, and the service reminder should be reset. If the light does not turn off, repeat the process.
range rover supercharge service light off
the service light will go off after a number of miles..... I believe mine went off after 100 or 200 miles
reset service engine light
To reset the oil service reminder on a 2009 Land Rover LR2, start by turning the ignition to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds, then turn the ignition off. When you turn the ignition back on, the oil service reminder should be reset. If it doesn't reset, repeat the process to ensure the steps were followed correctly.
via diagnostic port. Softwear problem on these vehicles stopping use of trip meter button.
To reset the service indicator on a 2008 Range Rover Sport, turn the ignition on without starting the engine. Press the accelerator pedal fully three times within ten seconds. After this, turn the ignition off, then start the engine to ensure the service light is reset. If it does not reset, repeat the process.
unfortunately this is not possible without service workshop dignostic software
To reset the service indicator on a 2005 Range Rover, first turn the ignition to the "on" position without starting the engine. Press the gas pedal three times within ten seconds, then turn the ignition off. When you restart the vehicle, the service indicator should be reset. If it doesn't reset, you may need to repeat the process or consult the owner's manual for further instructions.
you have to take to a rover dealer to put out the service light
HOW DO I RESET THE PAD WARNING LIGHT ON MY RANGE ROVER
disconnect the battery for 10 mins or turn the ignition switch back and fourth with the key in it
Yes, you can reset the service interval on a Land Rover Discovery 3 and Range Rover Sport without a computer by using the vehicle's ignition and pedal sequence. Turn on the ignition without starting the engine, then press the accelerator pedal fully down three times within ten seconds. After that, turn the ignition off and then back on to see if the service indicator has reset. Ensure to check your owner's manual for specific instructions, as the process may vary slightly between models.