I can tell you that Mitchell says that if you jump the Tc and E1 terminals of your datalink connector located next to the passenger side front strut tower, then turn the key to the on position with the motor off, and finally pump the brake pedal 8 or more times in under 5 seconds your ABS and Trac light should blink twice and the codes are cleared. I am working on one right now that it will not work on so I took it to the dealer.
Bring to a shop that has an ABS scanner
Because error codes only diagnos engine problems. ABS is part of the braking system, not the engine.
To reset the ABS and brake lights on a 2002 Toyota MR2, trying disconnecting the battery for 10 minutes. A Toyota dealer can also reset the lights.
The abs light came on because there is a problem with the abs ( Anti-lock Brake System). The abs light will not reset until the problem has been fixed. Once the abs system is repaired the light will reset itself.
how to reset abs warning light on 2000 gmc Yukon
The ABS light on a 95 S10 Blazer has to be reset by a mechanic or the dealer. Unplugging the battery on the vehicle will not reset the ABS light.
The abs light is on because there is a problem with the abs system. Until the problem is fixed the light will remain on. After the problem is fixed the abs light will reset itself after a short drive.
There is a problem with the anti-lock brake system. Have the ABS repaired and they will reset the light.
You have a problem with the abs system. Once the problem is fixed the light will reset itself.
You have a problem with the ABS system. Get it repaired and the tech will reset the light at this time.
You don't have to. When you have fixed the problem the abs light will reset itself.
The ABS light is on because there is a problem with the ABS system. Until the problem is fixed the light will remain on. After the problem is fixed the light will reset itself after a short drive.