good luck
Dave :)
Dont be a dick dave! people here are just looking for help. if you dont want to help then just leave... aloha
To reset the computer all you have to do is disconnect the positive battery cable from the battery. Wait about 5 minutes and then reattach battery cable.
**Before doing this, make sure that you have the code for the radio as it has to be input after the battery is connected***
The 2005 Town & Country OBD 2 port is on lower dash located between brake release and hood release
You can use a scan tool or unhook the battery.
Chrysler does not use inertia/reset switches. The fuel system is computer controlled with relays.
With a scan tool, or unhooking the battery.
The airbag light stays on when the computer has detected a malfunction and set a trouble code. The light can not be reset until the failure has been repaired.
Either use a scan tool, or unhook the battery.
A Chrysler Sebring does not have any reset switches.
You can use a scan tool or unhook the battery.
To reset the abs light you need to check the system for failure codes, repair the cause, and reset with a scan tool.
disconnect the battery for a few minutes.
Chrysler does not use reset switches.Chrysler does not use reset switches.
Chrysler doesn't use fuel shut off switches, the system is computer controlled with relays.
The 2001 Chrysler Town-AND-Country has a V6 engine.
The 2001 Chrysler Town-AND-Country has 12 valves.