0
to reset the oil change lite turn the key in the ignition to the on posicion right before cranking it. then press and release the the gas pedal compleatlly three time with in five secounds. the message center should blink.if not try again this time press the gas pedal four times.
What else can I help you with?
How do reset the oil change light on a 2005 avalanche?
turn key to on 'NOT STARTING ENGINE' press gas pedal to floor 3 times within 5 seconds will reset oil change message
How do I make Taurus Message Center dim.?
message center display light brighter after I disconnected the battery
Chevy Avalanche high mounted tail light out?
change the bulb
Change center brake light on Hyundai?
what do you have to do to change the center brake light
2002 Avalanche Change oil light will not reset?
Refer to owners manual
How do you change the running light lens on a 2003 Avalanche?
Check with the dealer but it is an assembly.
How do you change the Daytime Running Light bulb in a 2004 avalanche?
See a mechanic! I can guarantee you can't do it by yourself you need pop the hood to get light under the avalanche and then unscrew the bolt closest to the light then push.
What might cause a 1998 Sierrea SLE not to startSecurity light flashes on message center if that matters?
If the security light is flashing you need to change the ignition switch it self. It is likely worn out.
How do you reset the change oil now message in the message center on a 93 Oldsmobile 98 regency elite?
To reset the change oil message on a 1993 Oldsmobile 98 Regency Elite, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within five seconds. This should reset the oil change indicator light. If the message persists, you may need to check your vehicle's manual for additional steps.
How do you change third brake light on a 2005 Chevy Avalanche?
To change the third brake light on a 2005 Chevy Avalanche, first, open the tailgate and locate the two access panels on the rear of the cab. Remove the screws or clips securing the panels and gently pull them away to expose the light assembly. Disconnect the wiring harness from the old light, remove it, and then replace it with a new third brake light. Reconnect the wiring, secure the assembly back in place, and reattach the access panels.
What is and internet message light?
It is a message in a light
How do you know if resetting the change oil light on a Chrysler Town and Country is successful?
If it did have the message on, it will shut off. If the message was not yet displayed, you will not know.
