1. Turn the ignition switch to the ON position (Do not start the engine).
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
A 2002 Jeep Wrangler does not have a reset switch.
A person can rest the check engine light on a Jeep Wrangler by disconnecting the battery. This will also rest other warning lights on the dash.
Jeep does not have reset switches.Jeep does not have reset switches.
With a scan tool or with a battery disconnect.
The airbag light stays on when the computer has detected a malfunction and set a code. The light can not be reset until the failure is repaired.
You have to fix the cause of the code that turned the light on. You will need a scanner to read the code.
disconect pos battery cable for a few minutes
Jeep does not use inertia/reset switches.Jeep does not use inertia/reset switches.
looking at the motor, right side next to the power steering unit
After fixing the cause of the trouble code, you clear code with a scan tool.
How do you change the steering shaft in a 1990 Jeep Wrangler?
No reset switch on a Jeep. The fuel pump is computer controlled with relays.