To reset the theft alarm on a 1989 Chrysler New Yorker Landau, you typically need to turn the ignition key to the "On" position without starting the engine, then press the alarm reset button, usually located near the fuse box. If the alarm is triggered, it can prevent the car from starting, as the system is designed to immobilize the vehicle to deter theft. If you continue to experience issues, consult the owner's manual or a professional mechanic for assistance.
Chrysler does not use reset switches.
It doesn't have one. Chrysler uses relays to controll the fuel system.
Chrysler does not use inertia or cutoff switches. The fuel system is computer controlled with relays.
It doesn't have one. Chrysler uses relays to control the fuel system.
Could you be more specific? Are you asking about a wiring diagram for the heating system?
It can not be permanently disabled. It is disarmed with the remote or by unlocking the doors with a key.
A Chrysler dealer can run the VIN through their computer system and see if it was built with remotes when new.
Open the trunk and pull the plug on the left-hand side behind the lights.
The 1988 Chrysler New Yorker typically came equipped with a premium sound system that included a total of four speakers. Depending on the specific trim level and options, some models might have had additional speakers or enhancements, but the standard configuration featured four.
There is no fuse for the compressor itself, if the compressor is not working, the low pressure switch has activated and there is not enough refrigerant in the system. Have your AC system serviced by a good shop or your local Chrysler dealer.
It doesn't have a speedometer cable. The system is all electronic..It doesn't have a speedometer cable. The system is all electronic..
the amps are all located on the s[eakers them selves at least thays where they were on my 88 check it out