Hold down the sel. and adj. buttons at the same time, then release the sel. button. the hour will flash, use the adj button to set time!!
On my 2002 suzuki grand vitara I set the clock by pressing and holding the *disp* button to the right of the *<<* *>>* arrows( located at the right middle area of the stereo). Hold the disp button and push the << button to set the hours and >> button to set the minutes.
To set the clock on a 2004 Suzuki XL7, turn the ignition to the "On" position without starting the engine. Press and hold the "Clock" button until the display starts to blink. Use the "Hour" and "Minute" buttons to adjust the time, then press the "Clock" button again to confirm the settings. The clock should now display the correct time.
With the timing set at 10 degrees BTDC it is 800 RPM.
not sure but i would set it at 28
.031...From the 1996 Intruder 800 manual, .8-.9MM, which is more like .035.....
Radio has to be off. Then hold DSP and use CD/ Tune Track buttons to set hours minutes. If there is no DSP try CLK
Press and hold both the select and reset buttons for the dash meters, the clock face will begin to flash and allow you to set the clock using one button to select hours or minutes and the other to make the changes.
Press the up or down arrow (bottom right corner) for 2 seconds. Then use arrows to set minutes/hours. **MobileG4
Radio off. Hold DISP button while using CD tune/track buttons for minutes/hours
the clock is set for time
'how do I set the clock on a 2001 mercury mountaineer'
how do you set the clock on a 2001 oldismobile aurora