Want this question answered?
hawa hawa e hawa film ne
It is an outside temperature transmitter for a Sharp Wall Clock.
unable to set the temperature
One can purchase a Moonbeam clock from websites such as Amazon, LLBean, WestCloxSource, Partshelf, Moonbeam-Clock, eBay, Houzz and RestoredStyle. One may also visit the YouTube website to see a moonbeam clock being used.
HOW TO SET TIME1. Press [MODE] button for two seconds while in normalmode.2. The digits and colon will blink which indicates the timesetting mode has been enabled.3. Momentarily press the mode button until the date or time digit you wish to set is blinking and use the up or down arrow buttons on the back to set the correct time and date.
I had the same thing happen. I replaced the batteries in the outdoor sensor, but just got the two dashes on the clock that should display the outside temperature. After I replaced the batteries in the clock itself, the outside temperature then showed up properly on the clock. I also took all batteries out of both devices and replaced them in the order recommended in the directions on the back of the clock. I hope that helps.
If the clock is digital then it will say am or pm. Otherwise you can figure it out by looking outside and seeing whether it is morning AM or afternoon PM.
1st make sure your batteries are still working on the outside receiver. Then go inside and take the batteries out of your inside receiver (the clock). Put the new batteries in the clock and wait for the outside temperature to set. DO NOT SET THE TIME or anything else until the signal is received from the outside temp. If you get frustrated, take the outside transmitter inside and when it blinks the red light that is when the signal is sent, so wait for that. Hopefully this works for you.
On the main unit there is a reset button. Use an opened paper clip to click the reset button. Wait about a minute for the transmitter to send to main unit. Make sure that the transmitter and the unit are set for the same channel ie. both at one. The main unit will show waves for accepting the signal.
The chiming clock makes Anne Frank feel a sense of comfort and normalcy amid the difficult and hidden life she leads in the annex. It serves as a reminder of time passing and the world outside, offering a connection to the outside world.
After changing batteries and moving the clock the outside temp still does not register. could the remote have goe bad. It has worked for years.
The 2005 Jeep Liberty clock can be set by holding in the volume button. With the volume button held in the clock will flash. While the clock is flashing turn the tuning knob to adjust the time.