answersLogoWhite

0

For the crank shaft, there is a mark on the oil pump gear which should be straight up, same as the key way if you want to go by that. On the cam the pulley has a mark that should be pointing straight up toward the "V"

in the cover behind the pulley. Hope this helps.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where are the timing marks on 1980 ford courier?

on the harmonic balancer, at crank shaft


Where are the timing marks on a 98 S10 22 cam sprocket?

The timing marks for the cam sprocket on a 98 S10 is on the front. The marks for the crank shaft is on the oil pump gear.


On a 2003 Nissan altima what are the timing marks for the cam shaft and crank shaft and where do they line up?

there are paint marks on the chain. once you line it up it should be on tdc


How do you set timing on 4 cylinder ford contour?

you set timing by the marks on the cam shaft and the crank shaft. they should point at together to make it run right.


Diagram of Chevy 350 timing marks?

There are two timing marks on a 350 chev one for the cam shaft gear and one for the crank gear. The timing mark on the crank or the on on the bottom of the motor should be facing straight up and the cam shaft gear should be facing straight down this will put you lined up and top dead center.


How do you set timing 98 Subaru Outback?

Timing is done by Engine computer with imfo from cam and crank sensor . It is not adjustable. If you are replacing timing belt, a Gates timing belt comes with detailed instructions of belt and pulley timing marks. New belt has marks on it that correspond with cam shaft pulleys and crank pulley.


Honda Passport timing marks?

My honda passport 3.2 litter, to set the timing my belt has three timing marks on the outside of the belt, crank the motor over till you see the two belt marks towards the top of the cam shaft or around thier if one is at top the other cam can not be seen so botn cams have to be tilted set both belt marks to the cam shaft marks. When the belt comes off dont get the cams out of phase they tend to unwind a bit, put back. A nd the crank shaft has a green timing mart on it after you pull off the pulley and cover, so match the other timing belt mark on the belt to the crank shaft mark then put the tensioner back on now it is on dead set timing.


Where are the timing marks on the cam 94 Mazda 626 v6 engine?

i have a mazda 1994 626 v6 24 valve car and i think the timing belt just broke where are all the timing marks crank shaft and cams?


What is the timing for a Kia Sportage?

it is auto timed thru the cam shaft and crankshaft sensors.You cannot change it. The timing belt has timing marks when you change the belt in which you line up the crank and cams.


Where is the crank shaft position sensor on a 1995 Geo Tracker?

in the distributor


Where do you set crank and cam shaft marks to set timing on a 1996 Nissan Pathfinder?

Where do you set crank and cam shaft marks to set timing on a 1996 Nissan Pathfinder?" Did the timing belt snap ? if so the engine will have bent valves and require more work than just the belt. This is timing belt job is not one for the inexperienced diy mechanic. Not trying to be a wise guy, but get the manual, the timing mark set up isn't a simple explanation .


Timing belt marks for 1995 vw jetta 2.0 liter?

There are the letters O and T on the crank shaft pully. Look for similar marks on the intermediate shaft. If you remove the cover on the top of the tranny, you can look for the notch on the flywheel as well.