To set the timing on a Yamaha TY 175, start by removing the ignition cover to access the flywheel. Use a dial gauge to find the top dead center (TDC) of the piston, then align the timing marks on the flywheel with the mark on the engine case. Adjust the ignition timing by loosening the stator plate screws and rotating it until the timing light indicates the desired advance. Finally, tighten the screws and recheck the timing to ensure it is correctly set.
I think it will. If you look at biebandit.com and find the oem Yamaha parts for the motorcycles in question and check to see if they are the same part number, if they are then they will interchange. you can crosscheck different years too if you found a 1975 ty 175 cylinder for your 1975 dt 175. So check out bikebandit and see for yourself, they are the next best thing to a Yamaha dealer.
500cc of oil
800cc
The paint code for a 1974 Yamaha TY 250 is generally referred to as "Yamaha Red," which is often identified by the code 3B1. However, specific variations may exist depending on the model and production run. It's always best to verify with a Yamaha dealer or restoration guide for the most accurate information.
500ml. It's stamped on the side of the engine.
Ty Cobb is 6 feet 1 inches tall. He weighs 175 pounds. He bats left and throws right.
The correct spark plug for this model is the NGK B-7ES.
A fake company set up by a railroad to make more money
The 1974 Yamaha TY 250 typically requires approximately 350cc (or about 11.8 ounces) of fork oil per fork leg. It's important to use the correct viscosity oil, usually around 10W, for optimal performance. Always refer to the owner's manual or service manual for specific details and recommendations.
I had one of these when I was a kid late 70's I got it up to 40-45 mph back then
weak nmn ang light eh...........ty.....ty....ty..............ty..................yt.............ty..................ty
I'd have to double check, but I believe the cam and crank timing marks are SUPPOSED to be pointing directly at each other to be on #1TDC. Just turn the crankshaft 360 degrees, back to TDC, then point the distributor at #1. You shouldn't need to change the timing chain adjustment.