you have to know the specific code for the dvd player you are using... it should come in the instructions that came withe the controller, or search online the code for it if you don't have the instructions! Hope it helped!
See this link for instructions on how to set a Philips Universal remote, along with valid codes:
http://www.universal-remote.net/philipsmagnavox.htm
its on the manual
The Star Wars Luke Skywalker universal remote control uses the same programming set up and codes as the Star Trek Phaser universal remote. I downloaded the PDF and tested it on my light saber remote, works perfect.
She is a projector of lies and falsehoods.The projector is broken again.I operate the projector at the cinema.
It would depend on the brand of remote that is being used. Just look at the instructions that come with the remote to find out how to properly set it up.
i have the code book but how do i programme these codes to into it
If you go to your local Future Shop or Best Buy it is easy to find a universal remote which can control all of these devices. By going in store you can also consult an employee on how to set up the remote and which remotes are the best.
Your best bet is to go to the Quasar web site and look up the codes for your model and plug them into the remote. If that doesn't work, chances are the remote is not compatible with your set. But don't go running out to buy a new remote. Most of them have an auto-programming mode and can usually find most any piece of equipment it is aimed at. wjs1632
Almost certainly it does. There are many universal remotes so you will need to follow the set up instructions with the remote to configure the remote to operate with your model of television. Some instructions are better than others - read them carefully and follow each step for a successful configuration.
To set up a slide projector, one will need the correct equipment. Generally, one will need to connect the projector to a laptop or computer, then turn on the projector.
It is connected to your computer for programming, not your TV. It sends the infrared signal to the TV to control it once it has been set up.
I know this tv can be programmed with just about any universal remote or cable remote the onoly problem I've come across is once i programmed the remote and tv if i try to turn the volume up or down the channel goes up or down
A remote light switch is a switch that triggers a light by remote. You can get one installed through your local home department store and have it rigged up to a universal remote.