what is a screw
Just exactly the same way you screw into wood.
there is no translation for screw you
The mechanical advantage of a screw can be found by dividing the circumference of the screw by the pitch of the screw. In this case, the total mechanical advantage is equal to the circumference of the simple machine to which the effort force is applied divided by the pitch of the screw.
a screw, a bolt, or a nut.
Drive a flat blade screw driver into it. Then turn screw driver to on position.
in case of simple screw jack it's single start square thread in case of worm geared screw jack it's double start square thread double start gives greater speed but requires more torque ,hence worm geared :)
A number 4 size screw comes from the fact that it is the fourth in a series of screw sizes. The screw sizes start at number 0 with a diameter of 0.060" and increase by 0.013" for each size larger.
solenod
yes its used to start off screw holes
If you are trying to get a screw to stay on the screwdriver blade when you can't reach in with your fingers to start the screw. Soap or wax can also be applied to a wood screw's threads to get it to screw into hardwoods more easily. Beeswax is traditionally used by carpenters.
There is a large screw which goes through the coil pack into the engine block. That screw will get to hot and then cause the engine to stop or not start back when it's hot.
There should be a Phillips Screw on the side by the kick start remove screw and fill until oil comes out
There are a few specialty companies who offer Acme screw repair, including www.ballscrew-repair.com. You can get acme screw repair at www.lsitvc.com/. Go to the customer service and repair section and you can start contacting them right away.
By 'single threaded' you really mean single start thread. So there is just one continuous thread running up the screw. Double start thread means that two threads start from the point and run up the screw entwined with each other. For the same thread spacing the double start will screw into the wood twice as quick but require more torque to drive it. Double or Twin start often used with power screwdrivers.
There should be a screw located inside the hood on top of the front side marker housing. Once you remove the screw, start pulling it forward (the direction of where the vehicle is facing). There should be a screw located inside the hood, on top of the front side marker housing. Once you remove the screw, start pulling it forward (the direction of where the vehicle is facing).
Not unless you REALLY want to screw up your life.