After an emergency stop on a bike, you need to start on a low note and low speed. You will keep accelerating as you gain momentum.
During emergency stop, focus on not hitting the obstacle. Then turn on the emergency lights to indicate that you are now an obtsacle on the road.
Stop the machine.
A red coloured stop button can be used to either stop the machine normally, or to do an emergency stop in a hurry. It is larger and prominent to make it quicker and easier to smack the button with an open hand. The smaller green coloured start button is either level or recessed, meaning a finger has to be used to start the machine.The emergency stop button will twist when pushed and stay down, breaking the circuit. It has to be turned to release the button back for normal use and to use the start button again.
The function of a stop switch is to cut the ignition so the engine can stop. If the switch is in the off position and the engine isn't running, then to start the bike you'll have to put it to the on position.
Sounds like the porselin Valve!!!!
Friction is what ultimately stops your bike
If the bike has a license, then it is an official vehicle and you need to ride it on the road and stop for the ambulance and get on the shoulder of the road.
First make sure the bike is in neutral and push kick start down on right side of the bike.
No, the larger the vehicle the harder it is to stop.
This is the emergency engine stop switch located on the right handlebar next to the throttle. To be used in situations where you have to switch off the engine in an emergency, as the main ignition switch is located at the side of the bike and cannot be easily reached while driving.
You push the brake.
if the bike bike has set up for a while clean carbs take them apart and clean the jets gas goes bad and clogs the pasages up