change your motor oil. i would get it running and sell this 98. take the money and invest in a 86 gsxr 750 or 1100 .
The MODEL A engine firing order is 1,2,4,3, which means that the front cylinder fires first,then the second cylinder,then the fourth cylinder,the last the third cylinder.
On a Toyota Sienna, cylinder 4 is located on the driver's side of the engine, in the second position from the front. The engine is configured in a V-shape, so if you are facing the vehicle from the front, cylinder 4 will be the fourth cylinder in the sequence, counting from the front of the engine toward the back.
In a typical inline or V-type engine, cylinder number 4 refers to the fourth cylinder in the firing order or arrangement. In a four-cylinder engine, it's simply the last cylinder, while in a V6 or V8 engine, its position depends on the specific layout and numbering conventions used by the manufacturer. Cylinder numbering may vary between different engine designs, so it's essential to refer to the specific engine's service manual for accurate identification.
the answer my friend is blowing in the wind
Conducting a Cylinder Compression Test. Before conducting a compression test, disable the ignition and the fuel injection system if the engine is so equipped. Connect a remote starter button to the starter system. Connect a battery charger to the car to allow the engine to crank at consistent and normal speeds needed for accurate test result. Depress the remote starter button and observe the gauge's reading after the first engine revolution. Allow the engine to turn through four revolutions and observe the reading after the fourth. After testing all the cylinders. If one or more cylinders is much lower than the other, continue nder with testing those cylinder with the test. Squirt a small amount of oilring sealing into weak cylinder. Reinstall the compression gauge into that cylinder and conduct the test. If the reading increases with the presence of oil in the cylinder,.
The firing order of a 1988 Suzuki Samurai, which features a 1.3-liter four-cylinder engine, is 1-3-4-2. This means that the first cylinder fires, followed by the third, fourth, and then the second cylinder in that sequence. Proper adherence to this firing order is crucial for the engine's smooth operation and performance.
The firing order for the 1997 Kia Sephia with a 1.6-liter engine is 1-3-4-2. This means that the first cylinder fires, followed by the third, fourth, and then the second cylinder in that sequence. It's important to ensure correct ignition timing and firing order for optimal engine performance.
4 one for each cylinder Some Rover diesel engines only have 3 glow plugs, visible from the front of the engine. In the area where the fourth one would normally be (right-hand cylinder, viewed from front) there is no hole in the engine to receive one.
The firing order for a 1989 Holden Barina, which typically features a 1.3L or 1.6L engine, is 1-3-4-2. This means that the cylinders fire in the sequence of the first cylinder, followed by the third, fourth, and then the second cylinder. Always refer to the specific vehicle manual for confirmation, as variations may exist depending on the engine type.
Fuel injector?, wire? manifold leak?
On a 2006 Hyundai Sonata, the number 4 ignition coil is located on the engine's cylinder head, specifically on the passenger side toward the rear of the engine. To access it, you may need to remove the engine cover and possibly other components for better visibility. The ignition coils are typically positioned directly above each cylinder, and the number 4 coil corresponds to the fourth cylinder in the firing order.
The firing order for a 1980 Suzuki GS550 motorcycle is 1-2-4-3. This means that the first cylinder fires, followed by the second, then the fourth, and finally the third cylinder. This sequence is essential for the proper operation of the engine.