If the hose is cracked, loosen the clamps and replace the hose, if the leak is coming from the housing attached to the block then you have to remove the accessories and the mounting block (be carefull not to break or dissconnect the A/C hoses... it will damage the equipment and cause personal injury (I am not liable for any injury or damage to any equipment)) then remove the housing, clean the surfaces, replace the gasket (and would be wise just to replace the thermostat while you are at it) and put it back together.
The 2002 Dodge Caravan 2.4 liter engine cooling system has a coolant capacity of 5.5 gallons. The cooling system fluid should be 50 percent anti-freeze.
The coolant capacity for a 2000 Dodge Durango with a 4.7 Liter engine is 14.3 quarts. This is equal to 13.6 liters.
Two wire sensor very near where the upper radiator hose hooks to the engine.
The 2.5 Dodge is a non interference engine
Yes
No, the 2.0 liter 4 cylinder engine in a 2004 Dodge Neon is an interference engine
The coolant temp sensor is located next the the thermostat housing.
According to my Consumer Guide book : The Dodge 4.7 liter V8 engine is ( 287 cubic inches )
The engine coolant capacity for the 4.0 liter - OHV engine is ( 12 U.S. quarts ) and for the 4.0 liter - SOHC engine ( 14 U.S. quarts )
Check the engine coolant... Is it full? yes coolant level is full
The engine block coolant drain plug on 4.3 liter Chevy Blazer is located on the bottom of the engine, near the oil filter. It allows coolant to be completely drained from the block during maintenance.
Dodge, Chrysler, Plymouth no.