On newer models, you have to move the seat all the way forward, remove side trim cover, remove seat belt anchor bolt, remove seat rails retaining bolts, tilt seat upward, disconnect wires, remove seat...
pull the seat base out and then you will see 2 bolts that hold the seat back down to the floor, take the bolts out and the back will come out.
there are 5 seats. but if you put up the handrest between driver and passenger there is a sixth seat with a seatbelt.
It offered an optional,driver only,seat-mounted combination head and torso side airbag.
What year impala? For 2000-2004, the actual ground wire is Pin F on the heated seat relay driver (control module) located underneath the seat. That ground wire comes from the main harness coming from underneath the carpet to the seat, and ultimately ties into a body bolt below the drivers opening, rear of the left A pillar.
Disconnect the battery cables and then unplug any wires underneath the seat and there are 4 nuts on studs that hold the seat in, take the nuts off the studs and pull the seat out.
Check under the driver's side of the vehicle along the rail. It should be between the rear tire and rear passenger seat.
yes...if he sees you.
how do i take a drivers seat out of a 02 ford mondeo,do i have to disconect the battery before i take it out
Because the driver takes the front seat Because the back seat of a car is not in control like the driver. Because those members of the British Parliament who belong to the majority party take front seats. Those who are in the minority "take a back seat".
Put your seat belt on:)
If it has bucket seats there are 4 nuts on each seat that hold it to the floor as the seat sits on studs, take the nuts off the 4 studs and unplug any wiring harnesses under the seat and then lift seat off the studs and take it out.
Driver's Seat was created in 1978.