Take out the bench seat, and remove the back, take a look. Holes are small.
To remove the back bench seat in a 1998 Mercury Villager, locate the release lever or bolts at the base of the seat. Pull or unscrew the lever/bolts to release the seat and then lift it out of the vehicle. Make sure to disconnect any wiring connections if applicable before fully removing the seat.
This bench can be adjusted for different exercises but not for storage.
When you have a bench in front of you, a bench step up is when you step up onto the bench, take that foot off to replace with another foot, then back down.
Well in my 68 you lift slightly on the front of the seat and push back there is a clip it sits in underneath and u have to push back till u can raise it up. The back cushion is same principle. Assuming for bench seat.
If you're referring to the 2 'captains' chair with console bench seat, then yes.You should be able to take your way back 3 person seat and swap it into the middle position as a good test.
The parody goes like this Sitting in the front seat, sitting, in the back seat, "Get the f**k over here" got to make my mind up which seat can I take
Take the back seat out. Take the front seat out. Take the cover to the battery out.
Yes, but before they can take a seat on the bench, they have to first be confirmed by the Senate.
)( ===
There are bolts that you must remove in order to take out the front seats of a 2002 Monte Carlo. There are two in the back of the seat and two in the front of the seat. If you have heated seats you will also have to remove the wires for that before you take the seat out.
NO, it doesn't fold down. You can pop out the bottom bench and unscrew the seat belt bolts and you should be able to take the seat off.