0
What else can I help you with?
How do you change water pump on a 1995 Mazda protege?
you do nothing
How do you replace the oil pump on a Mazda Protege?
Could you tell me how would you replace the oil pump on a Mazda Protege?
What is the cost of a mechanic replacing a water pump on a 97 Mazda protege?
Replacing the 1997 Mazda water pump will cost approximately $300. The water pump will cost about $75 and will require four hours of labor.
How do you put on Serpentine belt on a 1998 Mazda protege?
This year Mazda protege does not have a serpentine belt. It has two belts, one for the alternator/water pump, and the other for the power steering and a/c.
How do you replace the water pump serpentine belt on a 1995 Mazda Protege?
powersteering belt off first, then water pump, each has its own ten.
Your 1992 Mazda Protege DX is running hot.Radiator replaced could it be the water pump?
Check the engine thermostat.
Where is the fuel pump on a 1992 Mazda Protege?
In the gas tank.
Where is the water pump located on a 1998 Mazda Protege?
The water pump is under the timing belt cover. To access the water pump, you must first remove both belts, the water pump pully, and the timing belt cover.
Where is the fuel pump located on a 1998 Mazda protege?
in the petrol tank
How do you replace fuel pump relay in 1998 Mazda protege?
location of fuel pump relay
How do you replace the water pump on a 1994 Mazda Protege?
To replace the water pump on a 1994 Mazda Protege, first disconnect the negative battery terminal and drain the coolant. Remove the serpentine belt and any components obstructing access to the water pump, such as the timing cover. Unbolt the old water pump from the engine block, clean the mating surfaces, and install the new pump with a new gasket. Reassemble everything in reverse order, refill the coolant, and check for leaks.
Mazda-Protege 1999 is overheating after some minutes of driving It may be the thermostat that is not working well if si how can you replace myself?
Check the timing belt Answer - My 99 Protege was leaking out coolant slowly out of the water pump. A seal on it had gone bad and the pump needed to be replaced. Haven't had a leak or an overheat since new pmp was installed.
