Every time you start and drive the vehicle the abs self tests itself. If there was a problem with the abs, the abs light would stay on until it is fixed. Also when the abs light stays on the abs system will not function.
You replace the brakes on an ABS S10 the same way you replace brakes on a non ABS S10.
Check your local wrecking yards for a good used one.
The ABS speed sensor is located on the rear axle or the transmission case of your car. Use the owner's manual to understand the parts well.
get your rotors turned. If it's the ABS turning on or off you might need a new sensor for the wheel. The S-10 ABS had a design flaw and the ABS sensors on the wheel sometimes break.
That is the ABS in operation.
Pull the fuse, but the abs light will remain on.
The ABS pump motor relay is not serviceable. It is part of the ABS modulator valve.
The abs brakes on the back of a 94 S10 are designed to help slow the truck down quickly. Without abs, the brakes can lock up and the truck could slide uncontrollably.
If your brakes are locking up it is because the ABS is not working.
Yes it does, I have one!
In the back end of the transmission.
The ABS system self tests itself every time you turn on the ignition. If there is a fault the light will illuminate. Repair the fault and the ABS system will test itself and reset the light if everything is good.