0
You plug a code reader into diagnostic port. Auto repair shops have them or you can buy one for around 40.00 some auto parts stores(make specific) The good ones can cost a lot of money & work on all cars. It will read error codes & then you look them up in a manual or online or a repair shop can look up for you.
You cannot do this as there are no OBD ports on vehicles preceeding about 1993. You'll have to diagnose the problem using trial and error... or take it to a garage.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the test connector on a 1995 Ford Ranger xlt?
The EEC TEST connection should be in the engine compartment by the Power Distribution Box in a 1995 Ford Ranger ( EEC - IV , OBD I )
Where is the diagnostic port on a 1994 Ford Ranger?
On a 1994 Ford Ranger ( which is OBD I , EEC IV ) should have an EEC TEST connection in the engine compartment ( P.S. I'm not a mechanic / technician )
Ford ranger idles rough and there are no codes that show?
Run a compression test to verify the condition of the engine.
How do you test the air conditioner relay on '97 Ford Ranger?
Swap the relay with another like relay.
Why is there Rough shift on automatic transmission 98 ford ranger?
The transmission fluid filter could be clogged. There could also be an electronic issue, run the test codes on the vehicle computer to see if a problem is shown.
What does fault code 512 mean for a 1993 ford ranger with a 4.0 engine?
Keep alive memory test failed
95 Ford Ranger 4-cylinder 8 spark plug compression test?
pounds of compression per cylinder
How do you test temperature sending unit on 89 ford ranger?
The temperature sending unit can be checked cold, and then hot, for resistance change. The test is performed with an ohm meter.
Where is the computer test plug located for a 1996 ford ranger XLT?
If by any chance you mean the Data Link Connector where you plug in a code reader on a 1996 Ford Ranger : It is located in the lower part of the dash , beneath the steering wheel and between the emergency / parking brake release and the inside hood release * it is behind a small removable plastic panel ( maybe it also flips up )
Ford Ranger error code p 0500?
P0500 is loss of vehicle speed signal. You need to test the speed sensor.
Where is the data link connector on a 1994 Ford Ranger xlt?
A 1994 Ford Ranger is OBD I / EEC IV and has an EEC TEST connection in the engine compartment by the power distribution box In 1996 , the Ford Ranger changed from OBD I / EEC IV to OBD II / EEC V and has a Data Link Connector in the dash , below the steering wheel , covered by a small removable plastic panel
How long does a 98 ford ranger 4.0 take to do ecm self test after codes have been cleared?
Hayne's Manual does not specify a definite amount of time or mileage. It says the engine may run rough for several miles while the computer re-learns itself.
