The fan belt cannot be tightened. The scenic has a tention pulley that automatically adjusts the belt. If the belt is slack, it is either the wrong size or it is stretched and needs to be replaced immediately as serious damage can occur in the event that the belt should slip off.
To tighten the fan belt on a Renault Master, a person needs to adjust the belt tension wheel. This wheel has a bolt that is inserted in a groove. The bolt can be loosened and then moved to the desired location to tighten the belt.
The cam belt which works the water pump. Cheers. Donna
To tighten the fan belt on a Renault Laguna, first, locate the belt tensioner. Using a suitable wrench, turn the tensioner clockwise to relieve tension on the belt. Once the belt is loose, adjust the position of the alternator or the component the belt drives to achieve the correct tension. Finally, tighten the tensioner back into place and ensure the belt is properly aligned before starting the engine.
To tighten the fan belt on a Renault Clio 1.2, first, locate the tensioner pulley. Use a wrench to loosen the bolts on the tensioner, then adjust the tensioner to increase the belt tension. Once the belt is tight, re-tighten the bolts on the tensioner to secure it in place. Finally, check the belt tension again to ensure it’s properly adjusted.
how do you tighten fan belt on l200
just in front of the altenator, there is a 10mm bolt, tighten that and it will tighten the fan belt
how to change Renault megane timing belt
You can tighten a fan belt by tightening the tensioner pulley. Pry to the left on the tensioner pulley and tighten it.
If the fan does not stop running after the engine is shut off in the Renault Scenic 2000, there could be a problem with the fan relay switch. The fan relay switch is located in the fuse box.
A faulty fan relay switch is likely the problem if the fan continues to run after the engine is shut off. Production for the Renault Scenic began in 1996.
theres no way to tighten it you will have to buy a new belt
first you have to locate the allready plced soket and then just tighten the belt