0
you cant.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you turn back the odometer on a 2006 Nissan altima?
BUY A NEW CAR WITH LESS MILES. IT IS ILLEGAL TO TURN BACK AN ODOMETER.
Where is the crankshaft postioning sensor on a 97 Nissan pickup xe 2400?
The 1997 Nissan pickup truck crankshaft position eight sensor can be found on the back of the engine. The positioning sensor will be halfway down the engine block.
How do you reset sensor light on 1985 Nissan pickup truck?
The only way to reset the sensor light on a 1985 Nissan pickup truck is to disconnect the sensor wiring. After 60 seconds, put the wiring back in place.
Where is the PCV valve on a 1992 Nissan pickup?
in back of the alt you can fill it but can not see it take alt out of way to get to it
Is it possible to use back brake pads on the front of a 1996 Nissan Maxima?
no
Speaker sizes of a 95 Nissan pickup xe front and back?
4 inch on door panels and 5 1/2 in the back wall
Where is the pilot bearing located on a 1995 Nissan pickup?
The pilot bearing sits in the back end of the crankshaft, where the transmission side is.
Where is the oxygen sensor on a 1996 Nissan hard body pickup?
if its a v6 there will be one after the cat and at least one before the cat if it has 2 cats there will be one after each cat and one before each cat any where from the exhaust manifolds on back good luck
Where is the vehicle speed sensor on a 1996 Nissan 200sx?
The 1996 Nissan 200 vehicle speed sensor can be found on the back of the transmission. The vehicle speed sensor will be in the upper left-hand corner of the transmission.
What car has a Red Capitol R on the back?
A 1996 Nissan skyline r34 r spec
How to change the brake light in a 1990 Nissan pickup?
Open the tailgate. About 5" back from where the tailgate closes, there are two 10mm screws on the edge.
Will a front grill from a 1994 Nissan Pathfiner fit on a 1995 Nissan pickup?
Yes! I did this to a 1994 Nissan 4x4. But you will also have to buy the headlights and marker lights. The metal behind the grill is all the same between the pathfinder and pickup truck from back then. The only other thing you will have to do is change the plugs on the end of the wiring harness for the lights but it is really simple.
