Turn key on and close all doors. Press the step button until "0 miles to service" is displayed. Then press and hold the reset button
Turn key on and close all doors. Press the step button until "0 miles to service" is displayed. Then press and hold the reset button.
Take it to the dealer and get it reset.
if you have an overhead console, just change the mileage intreval due. Press the step button until 0 miles to service is displayed. Press and hold reset until the mileage resets.
Turn the key on. Press step until 0 miles to service is displayed. Press and hold reset.
Not sure about the 98 but on my 2002 you step through the info screen and when it comes to perform service (usually for an oil change) you have to hold the reset button for at least 30 seconds before it resets. It's extra long so you don't reset it by accident. Hope this helps, John ajdickert@verizon.net
you reset it by hitting step until you see "miles remaining to service" then you hold reset button and it will change to 3000
The easiest way to reset the 'perform service light' on a 2003 Jeep Cherokee is to disconnect the battery for a few minutes. If this does not fix the problem, try turning the key on, but do not start the vehicle. Pump the throttle 3 times and turn the key off. Then start the vehicle. If the light is still on after that, there might still be something wrong with the vehicle.
Turn the ignition on, engine off. Press the brake pedal down twice, then the gas pedal twice in ten seconds. Key off, then on and should be reset.
It is the same as turning any other warning light you need a diagnostics computer
You add washer fluid or fix the fluid sensor.
It is quite simple. Turn ignition on, but do not start, press MENU, until display reads "service interval". Check the interval value displayed, and simply change it to another value using STEP. Press and hold RESET for approximately 3 seconds. Scroll further and display will read "change service interval". Select yes. Turn off ignition.