unhook it from both ends and blow air through it Disconnect the line at the carburetor. REMOVE THE FUEL FILTER. Blow air through this portion of the line. If possible, remove the line at the fuel tank and plug the outlet in the tank. Now blow out the line between the filter and the tank.
You might try looking for your fuel filter in the carburetor fuel inlet line.
can byou buy a permanent in-line fuel gauge for a 1992 corvette
If I were you I would just replace the fuel filter if it is cloged.
Remove fittings at both ends and use an air blower to clear out line.
Disconnect the fuel line at both ends, removed the fuel filter if it is an in-line filter, and blow the line out with an air hose from a compressor.
To unclog the fuel line of an Echo 409 blower, first, ensure the unit is turned off and cool. Remove the fuel line from the carburetor and inspect it for any kinks or blockages. You can use compressed air to blow through the line, clearing any obstructions. If the clog persists, consider replacing the fuel line or cleaning the fuel filter to ensure proper fuel flow.
front of carb, where fuel line runs in, it is behind the 1" fitting.
unclog a fuel line or unclog your filter and pump? the lines i think you can just disconnect the fuel filter and pump, disconnect all lines from the tank, and blow them out with air. i dont know if there's anything special about a 97 s10 but shouldnt be too hard if you have an air compressor. pumps and filters should be replaced, not repaired.
do you have to remover our drop the gas tank to replace the rubber line that connecting to the gas tank on a 1978 corvette
at the front of the carb behind the 1" fitting the fuel line runs to
Driver side front of the engine. Just follow the fuel line from the carb down to it.
The fuel filter on a 1990 Chevrolet Corvette is changed by unscrewing the fuel line from both sides of the filter and removing the retaining clips. The filter can then be removed and a new filter put in its place.