0
A come-along is a ratchet devise used for pulling or lifting. The short cable is used to secure the come-along to a beam or post and the long cable is used tie on to the load being moved. A lever on or near the ratchet (gear) is moved to its appropriate position to either pull or release the object being moved..
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do i pull picky bush out of ground?
Carefully......My son just found a unique way to do it... He wrapped a heavy rope around the base and used a comealong and yanked it right out of the ground.. The vines were as big as his fingers ...
How to replace radius arm bushings on a Ford F-150?
All you have to do is unbolt the nut off the back of the radius arm. Use a comealong and attach one end to the front framerail and the other to the hole in the radius arm, and pull the whole arm out of the bracket. After the arm is out of the mount, put on the new bushings. Use plenty of lube on the bushings. Always use poly bushings; they may squeek a little but they don't wear out. Then push on the end of the arm with your feet while a friend slowly releases the comealong. Put the rear bushing on the back of the arm and tighten the nut down with a big breaker bar.
How did African slaves get education?
They got their education by secretly learning it if their master didn't allowed because it was illegal. Sometimes, their masters tought the slave even though it was against the law. By secretly learning it, they could learn it off another slave or steal a book and educate themselves.
How do tosters work?
they just work they just work,work,work
The work you do on a machine is called work?
the work a machine does is the work outputwhat it takes to do the work is the work inputSources;The_work_that_the_simple_machine_does_is_called_the_work
The work that the simple machine does is called the work?
the work a machine does is the work output what it takes to do the work is the work input
How do you replace lower rear control arms on a Ford Expedition?
Jack up one side at a time,start on driverside first,its the worse side, put a jack stand under frame, one under axle, leave jack under center of rear end, let weight of truck down onto jack stands, jack jack back up alittle for extra safety,take wheel off for extra room. use a strong air impact wrench on nuts in frame, mine were 24 mm, and a 13/16 wrench on bolt head, it just fits. it takes some wiggling to get it on. you may have to knock the bolt back with a hammer, then cut head of bolt off with a 4 1/2 inch electric grinder, or air die grinder, you can torch it, but i ground mine off. push bolt back through the other way. on rear end, break nut loose with breaker bar, then use air wrench on bolt. knock bolt out. when installing new arms, you may have to use a comealong hooked to safety hooks under your bumper to shift rear axle alittle. put front bolt in other way in towards tank. tighten bolts. on pass side, you may have to knock bolts out with hammer and punch, but new arm and bolts should line right up without using comealong on pass side. also, lock tight nuts. hope this helps
If a Mexican were to come and live in the US what do they do here?
Work , Work , Work , Work , Work , Work ! They do what You lazy Americans don't . Mexicans work hard . They do it all !
What is the verb in you work late?
The verb in "you work late" is "work."
What is a work calendar?
A calendar at your work, for your work, that has your work schedule on it, etc.
Will American cd's work in Australia?
Yes it can work Yes it can work Yes it can work Yes it can work
What is the differences between work input and work output?
Work Output is the work done BY a machine. Work Input is the work done ON a machine.
