0
Skeleton keys are just regular keys except they usually have a funny looking shape to them . Skeleton keys will not work on any skeleton key hole because there not all the same shape and size . Therefore there's no one skeleton key that's the same .
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How does thefeul solenoid work on a Briggs engine?
Turn the key off, shuts fuel off.
How do you unlock a skeleton key door....without the key?
7 ways. 1 you go to amazon.com and buy a key. 2 you may be able to pick it with a small screw driver. 3 you hire a lock smith from the yellow pages. 4 pop the pins out of the hinges with a hammer and screw driver or nail sink. 5 you may be able to take the lock apart. 6 you pry the door open with a crow bar. 7 try the old credit card trick
How can you get a skeleton key out of an antique door if it is stuck there?
First, if the key is only slightly jammed, wiggling and jiggling it might work it loose. However, I am assuming that if you are asking this question, the key must be good and jammed. If that is the case, the only way I know of is the following; however, it involves destroying the key and therefore, you should be prepared to obtain a new key from a locksmith. First, hopefully the door is unlocked, or open. If it is closed and locked, you will have to try the following. Remove the hinge pins from the door by tapping them out with a hammer and a centre punch, nail, or other pointed metal instrument. Once the hinge pins are out, try pulling the door away from the frame from the hinge side. You should then be able to remove the door from the frame even if the deadbolt is locked. (Note: This assumes you are on the side of the door where the hinge pins are visible. If not, you will have to access the other side of the door via a window into the room. Good luck!) Once you have gotten the door open by these means (if necessary), remove the doorknob, then the escutcheon plates (face plates with the keyhole in them). This will expose the hole drilled in the door for the keyhole, and the lock case itself. Now take a pair of locking pliers ("Vise Grips") and grab onto the shank of the key as close to the lock case as possible. Work the pliers back and forth until the key breaks off. Hopefully, the break will occur as close to the lock case as possible. Now, remove the screws from the edge of the door which hold the lock case in place. You should now be able to slide the lock case out of the door. Unscrew the cover from the lock assembly and extract the broken piece of key, being careful not to disturb any of the tumblers (levers), springs, etc. Good Luck!
What is a example of a hydraulic skeleton?
jellyfish worms starfish sea urchins coral sea anemones
What is the proper name of a square key between a pulley and the motor shaft?
It is simply called a key
Will any skeleton key work on any door with a skeleton hole?
yes
What is the duration of The Skeleton Key?
The duration of The Skeleton Key is 1.73 hours.
What movie is scarier- the skeleton key or shutter island?
The Skeleton Key.
When was The Skeleton Key released?
The Skeleton Key was released on 08/12/2005.
When was The Skeleton Key created?
The Skeleton Key was created on 2005-07-29.
Who was the director of The Skeleton Key?
The director of The Skeleton Key was Iain Softley.
How much money did The Skeleton Key gross worldwide?
The Skeleton Key grossed $92,256,918 worldwide.
Why is the island of three skeleton key called six skeleton key?
6 people died on it
What is the ISBN of A Skeleton Key to Finnegans Wake?
The ISBN of A Skeleton Key to Finnegans Wake is 1577314050.
When was A Skeleton Key to Finnegans Wake created?
A Skeleton Key to Finnegans Wake was created in 1944.
Is there going to be a movie called skeleton key?
"The Skeleton Key" was released in 2005. It starred Kate Hudson.
How many pages does A Skeleton Key to Finnegans Wake have?
A Skeleton Key to Finnegans Wake has 400 pages.
