How does a steam train work?

Answer 1

Steam engines were the first engine type to see widespread use. They were first invented by Thomas Newcomen in 1705, and James Watt (who we remember each time we talk about "60-watt light bulbs" and the such) made big improvements to steam engines in 1769. Steam engines powered all early locomotives, steam boats and factories, and therefore acted as the foundation of the Industrial Revolution. In this article, we'll learn exactly how steam engines work! = Steam Engine Operation = The following diagram shows the major components of a piston steam engine. This sort of engine would be typical in a steam locomotive.

The engine shown is a double-acting steam engine because the valve allows high-pressure steam to act alternately on both faces of the piston. The following animation shows the engine in action:

You can see that the slide valve is in charge of letting the high-pressure steam into either side of the cylinder. The control rod for the valve is usually hooked into a linkage attached to the cross-head, so that the motion of the cross-head slides the valve as well. (On a steam locomotive, this linkage also allows the engineer to put the train into reverse.) You can see in this diagram that the exhaust steam simply vents out into the air. This fact explains two things about steam locomotives: * It explains why they have to take on water at the station -- the water is constantly being lost through the steam exhaust. * It explains where the "choo-choo" sound comes from. When the valve opens the cylinder to release its steam exhaust, the steam escapes under a great deal of pressure and makes a "choo!" sound as it exits. When the train is first starting, the piston is moving very slowly, but then as the train starts rolling the piston gains speed. The effect of this is the "Choo..... choo.... choo... choo choo-choo-choo" that we hear when it starts moving. On a steam locomotive, the cross-head normally links to a drive rod, and from there to coupling rods that drive the locomotive's wheels. The arrangement often looks something like this: In this diagram, the cross-head is connected to a drive rod that connects to one of three drive wheels for the train. The three wheels are connected via coupling rods so they turn in unison. = Boilers = The high-pressure steam for a steam engine comes from a boiler. The boiler's job is to apply heat to water to create steam. There are two approaches: fire tube and water tube. A fire-tube boiler was more common in the 1800s. It consists of a tank of water perforated with pipes. The hot gases from a coal or wood fire run through the pipes to heat the water in the tank, as shown here:

In a fire-tube boiler, the entire tank is under pressure, so if the tank bursts it creates a major explosion. More common today are water-tube boilers, in which water runs through a rack of tubes that are positioned in the hot gases from the fire. The following simplified diagram shows you a typical layout for a water-tube boiler:

In a real boiler, things would be much more complicated because the goal of the boiler is to extract every possible bit of heat from the burning fuel to improve efficiency.

Answer 2

A steam engine has a large boiler and a place under it where a fire burns. The boiler is basically a big tank with water. The firepit can have coal, wood, oil, or gas, depending on its design. Basically, the fire heats the water until it boils, and steam comes out a hole which has a pipe connected to it to funnel the steam into a chamber holding a piston.

The increased pressure in the chamber forces the piston back, uncovering a hole where the steam can escape. The piston is attached to a swivel point on a wheel. As the piston moves back and forth, the wheel turns because the piston is cranking the wheel via the swivel point.

The boiler needs to be refilled periodically as the escaping steam is water leaving the boiler. The fuel must also be replenished, or the fire will go out.

Answer 3

A steamboat uses an "external combustion engine". A burning wood or coal fire heats the water in a boiler until the steam pressure is very high. This pressure is released into the drive mechanism to turn the engine shaft, normally connected to one or more paddlewheels that move the boat through the water.

While somewhat "cleaner" than internal combustion, steam engines can be much more dangerous due to the high pressures involved. Steam leaks can injure workers, and too high a pressure can cause the boiler to explode.

Steam Engines

Fuel burned in the firebox boils water to steam in the boiler. The steam expands in the engine cylinder to drive the piston towards the crankshaft. The crankshaft turns and a timing gear opens a slide valve that allows the steam to exhaust, and permits the piston to return to the top of the stroke to repeat. The crankshaft turns a drive shaft or gear train that turns the screw (propeller) or the paddle wheel depending on the type of steam ship.

The modern version (as on an aircraft carrier) replaces the firebox with a nuclear reactor and the reciprocating engine with a steam turbine.

Answer 4

There are two kinds of steam engines--reciprocating engines and steam turbines. A steam reciprocating engine works a little like a car engine. It has a piston that moves back and forth in a chamber. It has a way to feed high-pressure steam into the chamber, and a way to exhaust steam to the atmosphere. If you wanted to get slick about it, you'd put a condenser in the exhaust pipe, convert the steam back to liquid water and dump the water back into the boiler. They still make these but they're small and used to teach kids how steam engines worked. Steam turbines are a different story. In these, steam is blown against the blades of a turbine wheel. The wheel spins, turning whatever it is you've got hooked to it. Steam turbines are used every day on ships and in power generating plants. As an addendum...this is not a practical method of repowering your Honda because there's nowhere to put the boiler.

Answer 5

it pushes against pistons which push connecting rods that turn the wheels