Too long an arc length allows the arc to wander creating a poorly shaped weld. The slag is usually too thin and can allow Oxygen in the air to attack the molten puddle which causes Porosity in the weld. Too short an arc length buries the slag and creates less heat which traps the slag and impurities. Keep in mind that electrode coatings help determine the correct arc length.
The length of arc ACB is 57.2.
find the arc length of minor arc 95 c= 18.84
Arc length is the distance from the tip of the electrode to the workpiece.
It is: 72-lenghth of major arc = length of minor arc
20/360=arc length/2pi*50; 1/12=arc length/100pi. 100pi/12=arc length. arc length=25pi/3 centimeters, which is approximately 26.17993878 centimeters.
Correct current,travel speed, electrode angle, arc length
why is it important only to strike the arc in the weld joint
The angle of the electrode, the speed of the electrode used to weld and the size of the electrode.
You can arc weld & then the flux will be in the rod.
The longer you strech the arc, the smaller the voltage. Current rises though.
Arc blow is a magnetic field formed in the weld area. It will pull the arc back and forth keeping it from being concentrated directly ahead of the electrode. Metal in some areas will not be melted and slag will flow into these voids trapping it. The arc can expel molten metal from the joint creating spatter. Arc blow can be very severe. You can avoid this by connecting the work lead to the end of the weld joint. Then work away from the work lead.
The length of arc ACB is 57.2.
The arc length is the radius times the arc degree in radians
yes
(arc length)/circumference=(measure of central angle)/(360 degrees) (arc length)/(2pi*4756)=(45 degrees)/(360 degrees) (arc length)/(9512pi)=45/360 (arc length)=(9512pi)/8 (arc length)=1189pi, which is approximately 3735.3536651
It just means length.
The legth of the gas nozzle can affect the MIG welding process because it modifies the "electrode extension" or so called stickout. The longer the nozzle the longer electrode extension needed to keep the arc away from it thus the value od the welding current and arc voltage changes. These changes will have a great effect on the weld.