Resistances in series act just as if they were one single resistor. The value of the single resistor is the sum of the individual resistors connected in series ... Ra + Rb + Rc etc. When several resistors are in series, the effective total is greater than the biggest one. Resistance in parallel act just as if they were one single resistor. The reciprocal of the value of the single resistor is the sum of the reciprocals of the individual resistors connected in parallel ... Total effective resistance = 1 divided by (1/Ra + 1/Rb + 1/Rc + etc.) When several resistors are in parallel, the effective total is less than the smallest one. Once you figure out the effective value of the series- or parallel-combination of many resistors, you handle them as if they were one single resistor, and you can work with the voltage and current: Current through any resistance = (Voltage across it) divided by (its resistance).
A parallel resonant circuit has at its heart an inductorand a capacitor. These are the two parallel components. They each react to voltage and current 180 degrees out of phase with each other. When we "hit" this circuit, called a parallel tank circuit, or just a tank, with voltage, one component is "putting energy into the circuit" while the other one is "storing it up" and then the two components switch roles. The result is that the tank will oscillate, and the frequency of oscillation will be determined by the value of the capacitor and the inductor.
Copper is the metal used for plumbing in houses, there are many reasons behind it 1. Copper is the main metal for electrical wiring compare with aluminium. 2. Copper is an excellent conductor of electricity and heat. 3. Copper is resistant to corrosion and very unreactive. Copper is malleable which makes it an ideal material for gas pipes and water pipes. 4. Copper is below hydrogen in the reactivity series and therefore it does not react with water. 5. Copper lead compounds in water are toxic. It was used for plumbing in the past time. For more information visit at: alliedallcityinc.com
flexible
In both fields, the machine will be exposed to outside stimuli, but only one type of machine will react to this stimuli. The automated machine will not react; even if there is an object blocking the automation, it will continue doing the same operation. Robots are made to react so, if something blocks or stops the robot, it will change operations to best fit the situation. Symbiosis Online Publishing
Nothing
Silver is a conductor, so it will conduct electricity. If exposed to much electricity, than silver wire will melt/deform.
B.Zn2+
Depending on the persons resistances to spicy food it can take between 10 seconds and 10 mins to react. Sometimes it starts once the food has passed through the mouth and sometimes it doesn't start until it has reached the digestive track.
B.NaC.Al
H+ Cu2+
Mg does react quite vigorously with water by not as much as metals higher up the reactivity series
The characterization of iron is "react with acids".
h
because copper is below iron in electrochemical series that's why it doesnt react with iron sulphate.
yes it reacts and combines with a halogen called fluorine and can also make calthrates
it uses magma and to heat and react with rocks that produce electricity
They "talk" to them in a series of clicks and squawks.