You should get a plunger stick it in the toilet and hold it in there till the water slows down and if that doesnt work close the toilet seat and wait til you hear a dweeling sound that means the water is going down.
They are called tank bolts.
I find it easiest to bolt the tank to the toilet first, then sit the whole unit on the flange.
seal to stop water from runing into tank located between tank and bowk
A raw egg in to the tank.
Install a tempering valve in water line feeding toilet. Tempering valve will mix hot and cold water together so warm water fills toilet tank which will stop condensation.
If you mean the toilet tank, it means you have a leak and water (and $$$ if you have a water meter) are being lost. It is the same as a leaky faucet. You need to find the source of the leak and repair.
The ONLY places any toilet can leak is between tank and bowl, or between bowl and floor.
you will have to cut the bolt between the tank and bowl (hacksaw blade works well, it will take about 5 min.to cut.) Always change all bolts and change tank to bowl gasket also.
An "unlevel" toilet flange might be a little difficult for a wax ring to seal, but could not in any way be responsible for a tank leak. If the tank is leaking between the tank and bowl, remove the tank, check the tank itself for a crack or defect, then check the flange gasket and tank bolts and gaskets. How do you know your flange is unlevel?
There are a number of measures that you can take to stop a leak in a gas tank inlet hose. You should ensure that both ends are fastened properly and sealed so as there would be no leaks.
There should be shut off valve called an angle stop towards the floor on the left side of your toilet. If you shut this valve by turning it clockwise this will stop the feed of water to the tank of your toilet.A:Your float valve may be defective or worn out
that is the only place to add to it!