An inclinometer, also known as a clinometer, measures the angle of inclination or tilt of an object with respect to gravity. It typically uses a weighted or pendulum-based system that responds to changes in inclination, allowing it to provide a reading of the angle being measured. Modern inclinometers may also use electronic sensors, such as accelerometers, to measure and display the angle digitally.
A sinometer, or inclinometer, is a device used to measure angles of slope or tilt. To use it, place the sinometer on the surface you want to measure and adjust the device until it indicates the desired angle. You can then take a reading of the angle displayed on the sinometer.
The device for measuring orientation is called an inclinometer or a compass. These devices help determine the position or orientation of an object or surface relative to a reference point or direction.
The types of mechanical work include static work, dynamic work, and intensive work. Static work refers to work done without motion, dynamic work involves movement, and intensive work focuses on the internal energy changes within a system.
Input work is the work done on a machine, while output work is the work done by the machine. Efficiency of a simple machine is calculated as the ratio of output work to input work. The efficiency of a simple machine is high when the output work is close to the input work, indicating that the machine is converting most of the input work into useful output work.
The formula that relates work and power is: Power = Work / Time. Power is the rate at which work is done, which is the amount of work done divided by the time it takes to do that work.
No. An inclinometer only measures vertical angle with respect to gravity. A theodolite adds measurement of horizontal angle to that measurement.
Information on clinometers: http://en.wikipedia.org/wiki/Inclinometer
This is known as a tiltmeter or inclinometer.
J. G. G. Reid has written: 'An electronic inclinometer design for the measurement of wire cable angles during Bongo plankton tows' -- subject(s): Collection and preservation, Design and construction, Inclinometer, Plankton
A procedure in which a joint motion were measured by an instrument. Measuring instruments includes Goniometer and Inclinometer.
Protractor, Inclinometer (often shortened to Clinometer), Theodolite. You could also add Compass and Sine Bar (though the latter really sets rather than measures an angle).
A sinometer, or inclinometer, is a device used to measure angles of slope or tilt. To use it, place the sinometer on the surface you want to measure and adjust the device until it indicates the desired angle. You can then take a reading of the angle displayed on the sinometer.
Astrolabe
Stanley D. Wilson has written: 'Foundation instrumentation' -- subject(s): Handbooks, manuals, Inclinometer 'Current trends in design and construction of embankment dams' -- subject(s): Congresses, Design and construction, Earth dams
In the United States the standard unit of measure for height is inches and feet. When babies are born they are measured in inches. At full growth people will say their height by using feet and inches. .
D. A. Secomb has written: 'Performance of an 0.81 in. diameter hemisphere-cylinder yawmeter at transonic speeds and varying Reynolds number' -- subject(s): Transonic Aerodynamics, Yawing (Aerodynamics) 'Performance of an attitude sensing head with flush pressure holes' -- subject(s): Inclinometer, Measurement, Pressure 'High speed wind tunnel tests on a vane cascade air brake'
Rear...yes. Front...no. Rear: reindex the trailing arm one notch up. This requires a inclinometer. One notch equals 8 degrees, and should provide a minimum 2 inch drop. Do not attempt if you have no idea what I am talking about....you'll screw it up. Front. need to get an adjustable beam, or buy dropped spindles. both are widely available.