A higher wattage HPS bulb may work with a ballast that is rated for a lower wattage bulb , but may appear to be dim and will not produce the rated light output. It is best to match ballast and bulb accordingly.
Wattage= current*voltage*power factor. Wattage=VI Cos(@)
No, it is not safe to exceed the recommended wattage on a fixture. The wattage rating indicates the maximum amount of power that the fixture is designed to handle safely. Exceeding this wattage can cause overheating, fire hazards, and damage to the fixture. Always follow the manufacturer's recommendations for bulb wattage.
Need to know the wattage to work out the amperage
The wattage of bulb one uses in a bedroom lamp depends on several factors. If it is a lamp used for back ground lighting or a night lamp, one would use a very low wattage bulb. If it is for a bedroom reading lamp, one would want a stronger wattage. The biggest factor on deciding what wattage to use is the wattage suggested by the lamp manufacturer. All lamps are marked with recommend bulb wattage.
Wattage = voltage times amperage. That's for DC. For AC there is a power factor PF = cos phi you have do multiply with.AnswerThe above answer suggests that power ('wattage') is an electrical unit, which it is not. In fact, power is defined as the rate of doing work, so the basic equation is work divided by time.
A higher wattage HPS bulb may work with a ballast that is rated for a lower wattage bulb , but may appear to be dim and will not produce the rated light output. It is best to match ballast and bulb accordingly.
It will work but not as efficient as the manufacturer designed it to. If motors are involved in the appliance they will run hotter as they will draw a higher amperage due to the lower voltage. Appliances with a wattage rating for heating elements will not reach their nameplate wattage rating.
Wattage= current*voltage*power factor. Wattage=VI Cos(@)
No, it is not safe to exceed the recommended wattage on a fixture. The wattage rating indicates the maximum amount of power that the fixture is designed to handle safely. Exceeding this wattage can cause overheating, fire hazards, and damage to the fixture. Always follow the manufacturer's recommendations for bulb wattage.
Yes, wattage is wattage, is wattage, is wattage. "Power" is calculated in wattage. It equals the voltage times the current in amps. In a light bulb, the resistive filament will cause a certain amount if current to flow making the filament hot and producing light.
The wattage can vary depending on manufacturer, capacity, model, etc. The wattage will be stated on a label fastened to the boiler.
If they are the same wattage and voltage, and have the same connector, yes.
Need to know the wattage to work out the amperage
NO preamp has wattage or a wattage rating. The only wattage involved in a sound system comes from the POWER amp
Find the wattage rating on the dimmer controller. This is the maximum allowable wattage that the lamp in the fixture should be. Lamp wattage ratings under the rated dimmer wattage is fine but do not install a larger wattage lamp that is over the dimmer control's rating.
wattage is nothing but power product of current and voltage p=v*i