To answer this question we would need to know the BTUs of the hot plate, the area of the hotplate's surface, the interconnecting area of the hotplates surface and the water container. The Heat capacity of water we can get from a reference book.
hot water is hotter cause hot water is always hot
THC is not very water soluble. That means that barely any THC will be absorbed by the water, although SOME will. That being said, evidence suggests that hot water will absorb slightly less THC than cold water, but the difference is pretty negligible.
Evaporation is an endothermic process, absorb heat.
Tepid is lukewarm water so obviously hot water!
You can but it would be wise not to. Most 60hz appliances will not work at 50 Hz. <<>> Yes, no problem at all. The frequency does not enter into the equation because the hot plate is a strictly resistive load.
I believe it is a hotplate
Yes, an induction hotplate is safe to use if you are careful. Make sure to use oven mitts when handling anything that is hot.
It depends on the ambient temperature, and the mass, composition and temperature of the hotplate.
im prety sure water turns in crystal at 300
hot|plate[ˈhɒtpleɪt] NOUNhot-plate (noun)a flat heated surface (or a set of these), typically metal or ceramic, used for cooking food or keeping it hot. "he scrubbed the oven and hotplate"
hot|plate[ˈhɒtpleɪt] NOUNhot-plate (noun)a flat heated surface (or a set of these), typically metal or ceramic, used for cooking food or keeping it hot. "he scrubbed the oven and hotplate"
The THD Hot Plate is a power attenuator for a car stereo system. You can use the THD Hot Plate to keep a power source to your amps. The Hot Plate is used by serious car stereo enthusiasts.
No because 300 degrees Celsius is extremely hot when you consider that the boiling point of water is 100 degrees Celsius.
It refers to hot people seeing cool water and being attracted to it.
Hot water, as hot water has more Kinetic Energy that increases of the rate of the rock salt being dissolved.
Dissolving is what happens to sugar when you put it into hot water. It goes from being a solid to being a liquid. Soap, when placed in hot water, will also dissolve.
This could be due to the filter being blocked or the hot water heater outlet may be slightly blocked and also check your aerators to your hot water taps