0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you install an electric fan on an 88 305 in a K1500 pickup?
first you need to measure the surface area of your rad. then got to your local parts place and tell them you need an aftermartet electric fan kit (with your predetermined fan size and the kit will have detailed instructions for installation
How much pressure does it take to put on a fan belt?
On what?
How do you install a booster fan on a furnace?
You should not need a booster fan on a furnace. If the duct system is properly designed there will be no need for the booster fan. If the system is not designed properly, you would be better off replacing it with a properly designed system. Actually, this doesn't answer the question. There is no way to know if he/she needs a booster fan without looking at the system. You can get very clear directions with photos at the following site: http://www.diynetwork.com/diy/he_heating_cooling_systems/article/0,,DIY_13894_2274829,00.htm
Is there any danger to powering a 12V 200mA case fan via USB at 5V 500mA max?
If wired correctly, this will not damage the fan or the USB port, as the fan will take less current at a lower voltage. The main problem with this arrangement is the fan would either not start, or would run very slowly, so probably useless for cooling anything. If you can get a 5V fan, not more than 500mA, this would be much more effective. (Note- If wired incorrectly, reverse polarity could damage both USB port and fan, short circuit could damage your USB port.)
Why does your bathroom or kitchen extractor fan run when the switch is turned off?
If the fan does not go off after 2 hours from switching it off and you know that the fan unit has a timer, then it is likely that the fan unit has either recently become faulty (if you know that it always went off before) or, if it is a new fan, that it has been wired up incorrectly. A fan unit which has a timer in it must have two separate "hot" wires feeding it:A "non-switched hot", which is permanently fed with power from the breaker on the main supply panel. After the fan has been switched on using the "switched hot" wire described below, this "non-switched hot" wire keeps the fan running for the length of time the timer has been set for.A "switched hot" wire which should be connected to the on/off switch that controls the fan.Depending on the actual design of the control circuitry inside the fan unit, if the above two "hots" have been connected to the fan unit the wrong way round, the result can be that the fan will "stay on and running" all the time, regardless of the position of the on/off switch for its circuit.The solution is to switch off all the power at the main breaker panel and, after you have checked that no wires are still "hot" or "live", re-wire the "hots" on the fan unit the other way round:You must ensure that the "switched hot" connection on the fan unit is no longer connected to the permanent hot feed wire coming from the breaker on the main supply panel. (It should now be connected to the switched hot wire from on/off switch that controls the fan.)The "non-switched hot" connection on the fan unit isconnected to the permanent hot feed wire from the breaker on the main supply panel. (Instead of to the switched hot wire from the on/off switch that controls the fan).More details:If the fan stays on after it has been switched off there is probably a timer inside the fan unit which will turn the fan off after a set time. If the fan does not go off after 2 hours from switching it off then either the fan unit has no timer but has been wired up incorrectly - so that it is not controlled by the on/off switch (see above) or the timer may have been set to stay on continuously.Sometimes a fan may come on when the switch for a light in the same room has been turned on but, if the fan has a timer, that timer will keep the fan running even after the light has been switched off.Sometimes a fan may have its own on/off switch, separate to another switch controlling a light in the same room. In that situation you might switch off both the light and the fan but, if the fan has a timer, the timer will still keep the fan running even after the light has been switched off.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
What is the antonym for extractor?
An extractor is a word for a fan that you often find in bathrooms. An antonym for extractor is introducer.
What is an Extractor fan?
the thing on top of the oven
When did they extractor fan come out?
round the 1980s to 90s
How does an extractor fan work?
An extractor fan is used for better ventilation and to extract moisture from the room, thus making the air less humid. It also helps to prevent condensation.
What is Extractor Fan?
Extract means "pull out", and a fan in this case is probably a propeller-like thingy used to move air. So an extractor fan is something that's used to draw air away from a certain area.
How is the dust taken away from a sanding machine?
Extractor Fan
What are the advantages of having a kitchen extractor fan?
There are many advantages to having a kitchen extractor fan. Kitchen extractor fans controls humidity and clears odors and fumes caused by smoke from cooking. The fans also helps to slow food spoilage.
How long does it take to install a ventilation fan?
Installing a ventilation fan is a tedious job. It can take 6 to 8 hours because of the size and weight of the object. However, the size of the ventilation fan is directly proportionate to the bathroom size. Bigger bathrooms have more air that need to be circulating to prevent fogging. Therefore, if one's bathroom is relatively small, that it will take less time for him to install a ventilation fan.
What are the main models available on the Extractor Fan online store?
There isn't a main model since these are replacement parts. They offer a wide selection of fans depending on the tanning systems you intend to install them in.
How is dust taken away from a sanding machine?
through an extractor fan
How long does it take for Justin Bieber to get fan letters?
How long dose it take to get fan letters
What cable would you use in a camper van to add a bathroom extractor fan?
use a cable that is specified on the fan AC OR DC
