A 100 amp service will supply your electrical current needs UP TO 100 amps.
When doing load calculations on a 100 amp panel it can only be loaded up to 80 amps.
50 amps
No you cannot.
Service wire for 100 amps requires AWG #3 copper.
1.5kva has enough electrical power to supply 100 volts of electricity that is at 15 amps. You can also supply 300 volts at 5 amps and 1000 volts at 1.5 amps.
A 200 ampere service provides 200 amperes per leg
The formula you are looking for is W = E x I. Watts = Volts x Amps.
A three wire home distribution service rated at 100 amps has a wattage capacity of;From L1 to L2 at 240 volts x 100 amps = 24000 watts or 24 kilowatts. From L1 to neutral at 120 volts x 100 amps = 12000 watts or 12 kilowatts. From L2 to neutral at 120 volts x 100 amps = 12000 watts or 12 kilowatts.
No you cannot.
No
Service wire for 100 amps requires AWG #3 copper.
You should not load a 125 amp panel any more than 100 amps.
A three wire home distribution service rated at 100 amps has a wattage capacity of;From L1 to L2 at 240 volts x 100 amps = 24000 watts or 24 kilowatts. From L1 to neutral at 120 volts x 100 amps = 12000 watts or 12 kilowatts. From L2 to neutral at 120 volts x 100 amps = 12000 watts or 12 kilowatts.
1.5kva has enough electrical power to supply 100 volts of electricity that is at 15 amps. You can also supply 300 volts at 5 amps and 1000 volts at 1.5 amps.
A 200 ampere service provides 200 amperes per leg
If a 9V supply is connected to a 100-ohm resistor, then the current is not 2 Amps,or even close to it.I = E/R = 9/100 = 0.09 amp.
a 1.5 kVa source of electrical power has the capacity to supply 100 volts at 15 amps, 300 volts at 5 amps, or 1000 volts at 1.5 amps.
max. 100 amps then fuse blows.
A 24 volt DC power supply provides DC amps, not AC amps. You cannot draw 1.8 amps AC from a DC power supply, without some kind of inverter stage.That is the answer to the specific wording of the question. Now the answer to the question I think was originally intended...If 1.8 amps AC is being supplied to a 24 volt DC power supply, what would the current supplied by the power supply be?Power is volts times amps, so power supplied to the power supply is 120 VAC (assumed) times 1.8 amps, or 216 watts. If the power supply is 100% efficient, then the power input equals the power output, so use the some equation to take 216 watts and divide by 24 volts, and you get 9 amps.Keep in mind, this is ideal state, assuming 100% efficiency, and no real power supply will be that.