Want this question answered?
90 kW on 480 volts single phase would be 187.5 amps. On 480 v 3-phase it would be 108 amps.
Your neutral May not be grounded good
Probably because years ago the voltage supply in most residential applications was 110/220V. It was increased to 120/240V to increase efficiency. If you use a heater element rated at 230V in a 240V application you will be "overvolting" it and will probably reduce the life of the element. If using an element rated at 240V in a 230V application you will be "undervolting" it and it will probably not get quite as warm as it is designed to.
That would most likely be a nickel and chrome alloy. Light bulbs use tungsten.
heating element stopped working
Hair dryers usually have a HIGH and a LOW setting. The HIGH heating element is about 8 ohms. The LOW heating element is about 32 ohms. voltage (squared) / resistance = power (watts) 120*120 / 8 = 1800 watts ( HIGH ) 120*120 / 32 = 450 watts ( LOW ) When the voltage switch is set to 240 volts, ALL it does is limit the HIGH/LOW switch to the LOW setting. 240*240 / 32 = 1800 watts ( LOW ) 240*240 / 8 = 7200 watts ( HIGH ) (the heating element would burn out)
In that case, it would be less efficient. Hot water rises to the top, mixing the water (if the heating element is at the bottom). When it is at the top, the water won't mix as well, and more heat would be wasted.
Is it just one mirror? I would look at a possible broken wire or heating element on the mirror. If it is both, I would look at a possible bad switch since it affects both mirrors.
46 amps
Check the appliance's specifications on the strip, tag or plate that is usually fixed either on the back or somewhere on the frame. On there you will find its required operating voltage and wattage that it draws.If your home has 240 volt line voltage just divide the watts by the volts for the answer.Example: a 2400 watt water heater for a 240 volt line using the formula watts / volts = amps would give you 10 amps. For a 120 volt appliance it would be 20 amps.
You would top-broil in a stoves broiling drawer if it has a flame or electric heating unit above it. You can also use an electric toaster/oven/broiler with a broil setting for an overhead heating element.
There are two conditions that would cause a breaker to trip off. One is an overload of the circuit and the other is a short circuit on the circuit. The heating element within the breaker is what monitors for circuit overloads.