0
How many audio signals could two channel Oscilloscope display?
Wiki User
∙ 10y ago
Two.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is CRO and AFO?
Audio Frequency Oscilloscope and Cathode Ray Oscilloscope
Can you build an oscilloscope using a computer monitor?
Yes you can. You need to build the oscilloscope circuits and interface them with your PC via parallel/serial/USB Port. Plus Build a program to get the data coming from the port and display it on the monitor.You can use your computer soundcard to view audio frequency signals (20Hz - 20KHz, sound card dependent) using software you can download from the web.WARNING - You can severely damage your soundcard if you exceed the input voltage range! Be sure to use a circuit to limit the input voltage to 1-volt and proceed with caution!
What Technique is used 2 transmit audio signals of television?
what is the modulation used in telivision for audio signals
What is a vectorscope?
A vectorscope is a special type of oscilloscope used in both audio and video applications
Can a Plasma withouy a monitor input be used as a PC monitor?
Almost all plasma televisions have video inputs. Often, component inputs can also be used as analog RGB inputs. The manual will always describe the type of inputs that can be accepted. A connector with VGA at one end to the appropriate connection at the display will be needed if the display supports analog RGB. HDMI inputs are also available on virtually all modern plasma displays. HDMI is compatible with DVI signals - the digital display interface being used on more and more PCs. If the PC does not have a DVI input, display cards are available at a low cost to be installed in desktop computers. A DVI to HDMI lead will be required. Once again, check the manual to establish which display resolutions are compatible with the monitor. Try to use the resolution that is the same as the display's native resolution. Note that HDMI supports audio on the connector but DVI is video only. If audio is needed, look for an analog audio input linked to the HDMI input. Most displays will have analog audio to support the use of DVI signals with separate audio signals.
What is trunk line?
A trunkline refers to audio, and it represents an "address" that determines where the video and audio signals need to be directed to. A trunkline refers to audio, and it represents an "address" that determines where the video and audio signals need to be directed to.
What is a trunk line?
A trunkline refers to audio, and it represents an "address" that determines where the video and audio signals need to be directed to. A trunkline refers to audio, and it represents an "address" that determines where the video and audio signals need to be directed to.
What is a powered audio mixer used for?
A powered audio mixer is used for combining, mixing, routing and changing the level, timbre or dynamics of audio signals. They can mix analog or digital signals depending on the mixer.
What is an analog mixing desk?
Analogue - In audio terms, this means that the audio signals will be stored, reproduced, or transmitted physically on or in something (i.e. vinyl records).Mixing Desk - A mixing desk is where an audio engineer controls and edits several audio signals simultaneously for recordation or transmission.Therefore, an Analogue Mixing Desk is used to control and edit analogue audio signals simultaneously for recordation or transmission.
What is the range of audio signals?
20B to 20 KB
Does s video cables carry audio signals?
No. They only carry separated color signals.
On a television remote what does SAP stand for?
SAP or second[ary] audio program[ming] is an auxiliary audio channel that carries alternate audio programming such as Spanish. It may contain other signals such as weather forecasts, control tones and the like. Sometimes it contains nothing.Go ahead an press it. If you get nothing, just press it again to go back to your main audio signal.
