when an architectural construction is built of load bearing arches, what is the height referred to as
If the line impedance is Z0 and the load is ZL then connect the load using a transformer with N turns ration. N=sqrt(Z0/ZL)
Within certain limits, story height is according to owner preference and designer's choice rather than by structural guidelines, however minimum and maximum height will be regulated by and according to a municipal code and every municipality will have different requirements according to the environmental impact, the urban planning, uniformity, etc. but an average western (ground to roof) story is between 12 and 15 feet in height and the internal height of the floor to ceiling is from 7 to 10 feet. The required space allocation for a structure is a percentage of the entire space with the remaining percentage for green area such as a yard or a courtyard, and this has an impact on the building dimensions which will have an impact on the internal and external design. Many people live in industrial zones say in a residential apartment, for example, and you will find the height of the average story to be greater than if the structure is located in a residential zone. As well the materials requirements will also be much different as the load-bearing regulations will be different. Otherwise the height of a residential story is from ground to roof or floor to ceiling. chrismar
You have to down load the abc family app im using it now
Yes. Using a condom will protect you from catching HIV. If you do not use a condom, then the risk of catching HIV will depend on the HIV-positive partners viral load. The higher the viral load the higher the risk. Even with an undetectable viral load, HIV can still be transmitted.
depending on your load resistance what are you using . suppose you are using 100 ohm load resistance than current will flow 1.5*4=6/100=0.06Amp and if you are looking for battery current capacity than mind it you are using series connection the current will not change remain same as one battery but voltage will change as i mention above 6 volt.
Before you can calculate the load bearing capacity of a scaffold, you will need to know there are three types of scaffolding; light duty, medium duty, and heavy duty. Now you can calculate the load bearing capacity by using the height to base ratio.
Thwe understanding of a load bearing structural frame where a steel frame supports the entire weight of the walls
A wall bearing no load.
Load Bearing - something that bears a load. Like a load bearing wall in a house. The wall is holding something up like the roof, another floor, etc.
Usually, a load bearing wall will be perpendicular to the roof ridge.
what is the load bearing weight for a 2x6x10
Capability of sustaining the imposed load ....
Non load bearing walls are walls that the weight of the roof is not supported on. Any wall that runs parallel will roof joists will be non load bearing.
LOAD BEARING WALLS Walls that must support the dead load of their own weight and the weight of subsequent bearing structural members placed upon them. In addition, load bearing walls must be capable to carry the load of "live" loads that are anticpated to be placed upon the the system without deflection that can degrade or negatively impact structural intergrity. NON LOAD BEARING Walls that are only intended to support themselves and the weight of the cladding or sheathings attached. Non load bearing walls provide no structural support and may be interior or exterior walls. Non load bearing walls must be braced to resist minimum 5 psf lateral loads.
Yes, you can run electrical wires in a load bearing wall.
The denser the styrofoam, the greater it's load bearing ability.
Non-load-bearing walls support only themselves; they are interior partition walls. They have a single top plate. While non-load-bearing walls might run perpendicular to floor and ceiling joists, they will not be aligned above support beams. As the name implies, load-bearing walls carry the structural weight of your home. Load-bearing walls in platform-frame homes will have double top plates. That is, two layers of framing lumber. Note: all exterior walls are load bearing; I got this from another site.