answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-09-17 11:42:09

About 2

About 2

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

User Avatar
Wiki User
Answered 2011-09-17 11:42:09

About 2

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


2 hours to 7 hours, depends on the engine size.





I understand that the starter is under the intake manifold and is quite a bit of work to replace. Could take several hours.


the clock on my 1996 Dodge Intrepid has an H and M on the right top. Use a pen or paperclip after turning the key until the power comes on, but before ignition. H changes hours and M changes minutes.


labor hours to replace evaporators dodge grand caravan se 2009


expect about 2 hours labor and a recommdation from him to replace both serp belts and the timing belt too the serp belts need to removed to access the pump and the water pump is driven by the timing belt and if its gotten wet by the coolant it wont last long and may leave you stranded then its about 2 hours labor to replace the timing belt


2.7L near 8 hours3.5L near 4 hours2.7L near 8 hours3.5L near 4 hours


my car 1997 dodge intrepid runs good for a couple of hours shuts down for 20 minutes backfires and runs again like nothing happen



Drop the complete engine and subframe. it pays 16 hours.



The average cost to replace a shift solenoid on your Dodge Durango is $175. The shift solenoid will cost approximately $50 and two hours of labor.


Labor time will be about 5 hours.Labor time will be about 5 hours.


I assume you submerged the starter. Remove the starter and place it in an over set at 150 degrees. Leave it for 12 hours. I should be throughly dry by then. If after this it does not function, replace it.


If it is a 2.7l engine it is a good four hours, and that is on a good day


Chrysler V6, six to eight hours. Mercedes/Dodge Sprinter, two to three hours.


IT ALL DEPENDS ON WHAT ENGINE IS IN THE CAR. JUST A VERY ROUGH GUESS ABOUT TWO HOURS LABOR AND ABOUT 95 TO 125 BUCKS FOR THE STARTER


Depends on cost of a new starter, and no more than an hours worth of labor. So 50 plus the cost of the starter. Call any auto store to get a rough idea on the cost of it.



Flat rate labor time is about 5 hours.


Next to the clock are two indented dimples. One has an "H" next to it and the other an "M". Pushing in the "H" one will advance the Hours and the "M" will advance the minutes.


The flat rate labor time is over 6 hours. It takes me around 5.


if the starter is under the intake manifold it is said that it takes 2.8 hours at a shop and $165-$375 for the starter depnding on where you go so could be between $500 - $700 to get done



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.